Epson ActionPC 2600 Handleiding productinformatie - Pagina 9
Blader online of download pdf Handleiding productinformatie voor {categorie_naam} Epson ActionPC 2600. Epson ActionPC 2600 11 pagina's. Product information guide
Pagina afdrukkenSIMM socket connector pin assignments
Active low logic
l
Tested Operating Environments
The following operating environments have been tested for
compatibility with the
system.
Microsoft MS-DOS 3.3 and later
Novell NetWare 3.12 and 4.02
Novell Personal NetWare
IBM OS/2 version 3.0
(Warp)
SC0 Open Desktop
Microsoft Windows 3.1 and later
Microsoft Windows for WorkGroups
Microsoft Windows NT version 3.5 and later
Microsoft Windows 95
Certified as workstation; tested as file server
l
Your system has also received Novell's "Yes, NetWare tested
and approved" certification as a workstation. As new
environments become available, these also will be tested.
Installation/Support Tips
Installing Diskette Drives
in the SETUP program.
the SETUP program.
EPSON ActionPC 2600, ActionPC 5500
Installing Hard Disk Drives
If you are installing a drive that cannot use the embedded
IDE interface (such as an ESDI drive), it is recommended
that you use a 16-bit, AT-type hard disk controller. If you
install a non-IDE hard disk drive and controller card, you
must use SETUP to disable the built-in IDE hard disk
drive interface.
When installing a hard disk drive, use the autodetection
feature in SETUP to select the correct type for the drive. If
this feature does not produce a match for the drive, you
can define your own drive type by selecting type 47 from
the Master Disk option on the Standard options
window. You can then enter the drive's parameters
yourself.
Software Problems
try the installation at high speed. If this does not work
properly, select low speed by pressing
numeric keypad). Try loading the program at low speed
and then switching to high speed, if possible.
its copy-protection method, try loading it at high speed. If
this does not work, load it at low speed.
Installing Option Cards
If you are installing a video adapter card, make sure you
disable the built-in VGA controller by setting jumper VJP1
to 1-2.
Upgrading the Processor
When you replace the processor, you need to check the
settings of several jumpers, as listed on page 4.
Booting Sequence
If you cannot boot the computer from the hard disk, make
sure the booting sequence in SETUP is set to A: , C : . Then
boot the computer from a system diskette in drive A.
Password
If you forget your password, you must discharge your
CMOS memory as follows:
1. Turn off the computer and remove the cover.
2. Disable the password by setting jumper JP28 on the system
board to 1-2.
3. Turn the computer on, leave it on for a few seconds, then
turn it off again.
4. Set jumper JP28 back to 2-3 to select the system board
battery.
5. Turn on the computer and run SETUP to enter a new
password, if desired, and the system configuration.
8/31/95
Ctrl Alt -
ActionPC 2600, ActionPC 5500 - 9
(on the