diLUSSO CC604MBT Installatie- en bedieningshandleiding - Pagina 8

Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} diLUSSO CC604MBT. diLUSSO CC604MBT 16 pagina's.

3. Operating Instructions

Touch Controls

The controls respond to touch, so user does not need to apply any excessive force while using the

•

Use the ball of the finger, not its tip.

•

A beep will be heard each time a touch is

•

registered.

Make sure the controls are always clean, dry,

•

and that there is no object (e.g. a utensil or a

cloth) covering them. Even a thin film of water

may make the controls difficult to operate.

Start cooking

After power on, the buzzer beeps once, all the indicators light up for 1 second then go off, indicating that

the ceramic hob has entered the stat of standby mode.

Touch the ON/OFF

•

A suitable pan is placed on the desired cooking zone. Make sure that the bottom of the pan and

the surface of the cooking zone are clean and dry.

•

Touch the heating zone selection to select the zone that the pan is put on.

•

Adjust the power level setting by using the "-" or "+" buttons on the control panel. If power level

is not set after 1 minute, the ceramic hob will automatically back to standby mode.

•

Power level setting can be adjusted any time during cooking by first touching the zone selection

and then adjust the setting by using the "-" or "+" buttons on the control panel.

Finish cooking

After cooking is done, select the cooking zone that is needed to be switched off.

•

Cooking zone is turned off by using "-" button to 0 power level OR press both "+" and "-" at the

•

same time.

Turned the complete unit off by pressing the ON/OFF

•

Beware of hot surfaces

When the ceramic cooktop is hot, the hot hob warning indicator "H" will light up next to the respective

zone section control. Don't touch the glass plate until the indicator goes out. It can also be used as an

energy saving function if you want to heat further pans, use the hotplate that is still hot.

Version 01

button once. All the indicators show "-"

button.