Motorola HMN9038 - HMN 9038 - Headset Gebruikershandleiding - Pagina 14
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Motorola HMN9038 - HMN 9038 - Headset. Motorola HMN9038 - HMN 9038 - Headset 24 pagina's. Professional two-way radio
Pagina afdrukken
OPERATIONS
Turn the Radio On/Off
Turn the On-Off/Volume knob clockwise. You
will hear a beep and see the Transmit Light
flash momentarily to indicate the radio is on.
To turn the radio off, turn the On-Off/Volume
knob counterclockwise. You will hear a click
to indicate the radio is turned off.
Adjust the Volume
Hold Monitor button down to listen to audio
level while rotating On-Off/Volume knob.
Rotate knob clockwise to increase and coun-
terclockwise to decrease volume.
To Send/Receive Messages
Check channel activity by pressing Monitor
button. You will hear static if the channel is
clear to use. Do not transmit if someone is
talking on channel.
1. To send messages, press Push-To-Talk and
speak into radio. (To maximize clarity, hold
radio 1 to 2 inches from mouth). Fig. M
2. The Transmit Light will glow continuously
when sending messages.
3. To listen for messages, release the Push-To-
Talk button.
FIG. M
See page 15 for range information.
Time-out Timer:
The Time-out Timer feature prevents channel
congestion and helps extend battery life. The
radio will sound a warning tone if the Push-
To-Talk button is pressed for 60 continuous
seconds and will stop transmitting.
12
Scan (Optional)
Some M-Series models have Scan. Scan
allows you to monitor the radio's pro-
grammed channels and code. When the
radio detects someone talking, it stops
scanning and locks in on the active chan-
nel. It allows you to listen and talk back
automatically to the person transmitting
without having to switch channels.
Note: To communicate in scan, your radio
must be set to the same frequency and
code as the other radio(s) in your group.
To Use Scan Feature
1. Move the Channel Selector knob to the
"s" position (Fig. N). The radio will scan
the radio's programmed channels and
code in sequential order.
2. When the radio detects someone talking,
you will hear the message.
3. Press Push-To-Talk button to talk back on
the channel.
In scan, you will always transmit back to
the channel which last sent a message.
4 Channel Model
FIG. N
Notes:
• In scan, after you receive a message, the
radio will remain on that channel for three
seconds before returning to scan mode.
• If you set the Channel Selector knob to
the "s" position (scan mode) and no activ-
ity is detected, you will transmit on chan-
nel 1 when you press the Push-To-Talk