Motorola MTP850 Installatiehandleiding - Pagina 4

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Motorola MTP850. Motorola MTP850 8 pagina's. Digital car kit
Ook voor Motorola MTP850: Basis gebruikershandleiding (42 pagina's), Snelstarthandleiding (2 pagina's)

Pagina afdrukken

Table 1: FTN6790B Specifications

Input Voltage

Range

Output Voltage

Max. Output

Current

Dimensions

(regulator unit

block)

Input cable

Output cable

Installation

1. The positive supply to the regulator should be taken from an

ignition switched source. This can be connected to the same

supply as used for ignition sense to DCK control box (green wire).

The positive supply must be fused at maximum 1 A rating.

2. Connect coaxial cable end to 5 V input terminal on diplexor unit.

3. Run supply cable to selected connection point, ensuring that it is

secured from being damaged and does not interfere with any

vehicle controls or airbag deployment.

4. Connect grey regulator positive feed wire to ignition sense feed,

via 1 A fuse (using holder and connectors supplied).

Specification

7–30 V

5 V

40 mA

41 x 12.5 x 12.7 mm

Twin Figure-8

Length: 560 mm

Negative marked black

tracer line

RG174 Coaxial Cable

Length: 550 mm

Terminated FME Jack (f)

Centre contact positive

supply

Kit Content

Regulator unit

moulded with

input and output

cables

1 x Fuseholder

1 x Fuse 1A rated

2 x Blade

connectors - red

insulated