Motorola TLKR T92 H2O Gebruikershandleiding - Pagina 8
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Motorola TLKR T92 H2O. Motorola TLKR T92 H2O 24 pagina's.
Pagina afdrukken
3. Press the PTT button to exit menu or
continue set up.
In order to transmit your call tone to other radios, set up the
same channel and Interference Eliminator Code on your radio
and press
Call Tone button.
Voice Operated Transmission
Transmission is initiated by speaking into the microphone of the
radio instead of pushing the PTT button.
1. Press
Menu button 4 times until
on the display. The current setting (L1-L3) will flash.
2. Press
or
to select the sensitivity level.
3. Press the PTT button to exit menu or
continue set up.
L3 = High Sensitivity for quiet environments
L2 = Medium Sensitivity for most environments
L1 = Low Sensitivity for noisy environments
Note: There is a short delay between the time you start
talking and when the radio transmits.
Dual Channel Monitor
Enables you to scan the current channel and another channel
alternately.
Menu button to
(
)
icon appears
Menu button to
To set another channel and start Dual Channel:
1. Press
Menu button 5 times until the Dual Channel
icon appears. The Dual Channel will flash.
2. Press
or
to select the channel then press
button.
3. Press
or
to select the Interference Eliminator Code.
4. Press the PTT button to exit menu or
continue set up.
5. The radio starts to Dual Channel.
Note: If you set the same channel and code as the current
channel, Dual Channel Monitor OFF.
Silent Mode (Vibrate Alert)
Silent Mode (Vibrate Alert) notifies you that your radio is
receiving a message. This is useful in noisy environments.
When the alert is on, the radio vibrates once every 30 seconds
when you receive a message on the channel and code you set.
1. Press
Menu button 7 times until Vibracall
displayed. The current setting will flash.
2. Press
or
to change the setting to On/Off.
3. Press the PTT button to exit menu or
continue set up.
Keypad Tones
You may enable or disable the speaker key tones. You will hear
the key tone each time a button is pushed.
1. Press
Menu button 8 times until Keypad Tone
appears. The current setting On/Off will flash.
Menu
Menu button to
icon is
Menu button to
icon
7