Motorola EASE44CONNECT-2 Gebruikershandleiding - Pagina 28
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Motorola EASE44CONNECT-2. Motorola EASE44CONNECT-2 44 pagina's. 4.3" wi-fi video baby monitor
Ook voor Motorola EASE44CONNECT-2: Gebruikershandleiding (38 pagina's)
Pagina afdrukken
11. Help
Display
• Try recharging the battery pack.
• Reset the Units. Unplug both the Units' electrical power, then plug
them back in.
• Is the Unit switched on?
• Press and hold the ON/OFF button 0 on the Parent Unit for 3
seconds to switch it ON.
• Is the correct camera selected? Change the camera number, if
necessary.
• Is the video display turned on? Press the VIDEO ON/OFF button
V to turn it ON.
• When operating using batteries only, the display will go blank
after 5 minutes or 30 minutes or 60 minutes to save power
(depending on video settings). The Unit is still active and will give
you audio alerts. You can reactivate the screen by pressing any
button.
Registration
If the Baby Unit has lost its link with the Parent Unit
• If the Baby Unit is too far away it may be going out of range, so
move the Baby Unit closer to the Parent Unit.
• Reset both the Parent Unit and Baby Unit by disconnecting
them from the electrical power. Wait about 15 seconds before
reconnecting. Allow up to one minute for the Baby Unit and the
Parent Unit to synchronize.
• See 2.3 Registration (Pairing), if there is a need to re-register the
Units.
Interference
Noise interference on your Parent Unit
• Your Baby and Parent Units may be too close. Move them further
apart.
• Make sure there is at least 1 to 2m between the 2 Units to avoid
audio feedback.
• lf the Baby Unit is too far away, it may be out of range. Move the
Baby Unit closer to the Parent Unit.
28
Help