DiMarzio Angel DP230 Installatie-instructies
Blader online of download pdf Installatie-instructies voor {categorie_naam} DiMarzio Angel DP230. DiMarzio Angel DP230 2 pagina's. Magnetic soundhole pickup
Pagina afdrukken1388 Richmond Terrace • PO Box 100387
Staten Island, NY 10310
www.dimarzio.com
FIG. 1
Pickup Output Jack
FIG. 2
Clamp Screw Head
Clamp Screw
Clamp
FIG. 3
THE ANGEL™ DP230
INSTALLATION INSTRUCTIONS
The Angel™ is a magnetic soundhole pickup designed to work with standard bronze strings,
but nickel - wound and compound strings can also be used. It will not work with nylon strings.
[FIG. 1]
The soundhole must have a minimum diameter of 3½ inches (89 mm).
INCLUDED IN THIS PACKAGE
(1) The Angel™ soundhole pickup
(1) 12 - foot (3.5 meter) cable
(1) 20 - inch (50 cm) endpin jack cable assembly
(1) ⁄ - inch Allen wrench
(2) self - adhesive cable retainer clips
(1) spare set of pickup mounting cushions
(1) instruction sheet
(1) warranty card
There are two ways to install The Angel™ soundhole pickup. The quick installation uses the
included 12-foot (3.5 meter) guitar cable out of the soundhole. The professional installation
(see reverse) uses the included pre-wired endpin jack.
THE ANGEL™ QUICK INSTALL
Loosen the clamp screws on both ends of the pickup top plate using a small Phillips
screwdriver until the clamps are open wide enough to mount the pickup on the top of the
guitar. [SEE FIG. 2] Then slide the pickup into the soundhole.
For small soundholes, it may be necessary to remove one or both clamps, slide
the pickup into place, and then reassemble the clamp(s) once the pickup is
correctly positioned. When reassembling the clamps, be sure they slide into the
slots molded into the pickup housing.
We recommend installing the pickup as close to the bottom edge of the ngerboard
(towards the neck) as possible.
Adjust the pickup so that it is centered in the soundhole and the pole pieces are aligned
with the strings. [SEE FIG. 3] A slight mismatch between your guitar's string spacing and the
spacing of the pole pieces will not affect performance.
Tighten the clamp screws rmly, but do not over - tighten. Over-tightening can damage the
pickup or guitar nish.
Once the pickup is securely installed, you can plug the 12 - foot (3.5 meter) guitar cable
directly into the pickup output jack and hang the cable outside the soundhole.
The pole pieces of The Angel™ are preset for standard bronze acoustic strings (four wound
strings and two plain), but this setting is only a basic reference point. The pole pieces are
adjustable with the included ⁄ - inch Allen wrench to provide the best balance for your
speci c guitar. Raising a pole piece will increase the output from its string, while lowering it
will decrease it.
IMPORTANT: The pole pieces have a maximum downward adjustment range. When you
encounter additional resistance at the bottom of the adjustment range, do not force the
pole piece further. This could result in permanent damage.