Motorola MCS 2000 Gebruikershandleiding - Pagina 14
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Motorola MCS 2000. Motorola MCS 2000 20 pagina's.
Ook voor Motorola MCS 2000: Installatiehandleiding (14 pagina's), Retrofit-instructies (11 pagina's)
Pagina afdrukken
MCS 2000 Model I
Sending a Selective Call
Press the call button (12) or select the menu CALL as
previously described. Enter the ID via the keypad or
use the mode selector (D) to scroll to the ID you wish
to call. Press the PTT (F) to transmit the selective call
to this ID. If automatic Selective Call is disabled, the
radio exits Selective Call after the transmission. If
automatic Selective Call is enabled, the radio will
remain in Selective Call until you exit.
Call Alert
See trunking section for more details.
Telephone Interconnect
To make a call through the telephone system in the
conventional mode your radio must send access and
hangup codes to the system. The access code can be
transmitted in either of two ways, depending on how
your radio is programmed.
Immediate: The radio automatically sends a pre-
stored access code as soon as the telephone
interconnect button (7) is pressed.
Delayed: Press the Select button (13) or the PTT (F) and
the radio sends the pre-stored access code.
After the access code is sent, you should get a dial
tone. (If no dial tone sounds, exit the function to hang
up.) Now press the Select button (13) or the PTT (F).
The radio then transmits the number.
The call is then handled as described under "Sending
a Telephone Call" above.
Status/Message
Select the menu STATUS or MESSAGE as previously
described. The last acknowledged status or the first
message will be displayed. Use the mode selector (D)
to scroll through the lists of possible statuses or mes-
sages. When the display shows the desired status or
message, press the select key (13) to transmit the sta-
tus or message. Four beeps will sound to indicate that
the status or message has been received. The radio
will automatically exit the status/message feature. If
the status or message is not received, the radio will
display
NO ACK
and generate a continuous tone. Press the select (13)
key to transmit the status or message again or exit the
function.
MDC Repeater Access (RAC)
MDC repeater access will select a repeater for trans-
mission. Consult your system administrator for more
information.
page 14
68P81083C48-B