Motorola RADIUS GM300 Servicehandleiding - Pagina 28
Blader online of download pdf Servicehandleiding voor {categorie_naam} Motorola RADIUS GM300. Motorola RADIUS GM300 49 pagina's. 16-channel, conventional fm radio
Ook voor Motorola RADIUS GM300: Servicehandleiding (28 pagina's), Gebruiksaanwijzing (18 pagina's), Gebruiksaanwijzing (19 pagina's), Gebruikershandleiding (37 pagina's), Gebruiksaanwijzing (2 pagina's)
Pagina afdrukken
Name of Manual
In UHF radios, for example, the latches are loaded with
data to give 5 kHz (or 6.25 kHz) at the output of the
divide-by-R counter when the reference signal is
applied at U101-1, and 5 kHz (or 6.25 kHz) at the out-
put of the divide-by-N counter when the VCO is oper-
ating at the desired receive injection or transmit
frequency.
During the frequency synthesis, the divide-by-A and
divide-by-N counters begin counting down from the
programmed values (A and N respectively) at the same
time. The modulus control line U101-12 is low so the
divide-by-127/128 prescaler divides by 128. Therefore,
the effect of the prescaler U102 is to divide the VCO
output by 128 and apply it to U102-8. When the divide-
by-A counter completes counting down, the control
logic sets the modulus control line high, and the
divide-by-127/128 prescaler divides by 127 until the
divide-by-N counter completes the programmed value
on N. After the divide-by-N counter completes count-
ing down, the counters are set back to their pro-
grammed values. The effect of the prescaler and
divide-by-A, divide-by-N counters is to divide the
VCO frequency by a number, N, where:
March, 1997
Figure 2-1. Receiver IC Block Diagram
The output of the divide-by-N counter is equal to:
When the phase-locked loop is locked:
f
VCO
The reference oscillator frequency is 14.4 MHz and the
output of the divide-by-R must be 5 kHz. Therefore:
The values of A and N are dependent on the desired
VCO frequency which is equal to the transmit fre-
quency, or to the receive frequency minus 45.1 MHz
(for UHF radios).
The 5 kHz outputs of the divide-by-A and divide-by-N
counters are applied to phase detector A. The output of
68 No.
N = 128 x A + 127 x (N-A) = 127 x N + A
f
/ (127 x N + A)
VCO
/ (127 x N + A) = 5 kHz = f
R = 14.4 MHz / 5 kHz
N = integer part of N
A = remainder of N
Theory of Operation
RF Board
T
/ N
VCO
/ 127
T
/ 127
T
2-3