Motorola CP040 Service-informatie - Pagina 13

Blader online of download pdf Service-informatie voor {categorie_naam} Motorola CP040. Motorola CP040 48 pagina's. Commercial radios uhf1
Ook voor Motorola CP040: Gedetailleerde servicehandleiding (28 pagina's), Service-informatie (46 pagina's), Gebruikershandleiding (18 pagina's), Service-informatie (30 pagina's)

VHF Transmitter

3.3

Harmonic Filter

The harmonic filter consists of components C130-C136 and L130-L132. The harmonic filter is a

seven-pole elliptical low-pass configuration, optimized for low insertion loss, with a 3 dB frequency

of approximately 180 MHz and typically less than 0.8 dB insertion loss in the passband.

3.4

The harmonic filter presents a 50Ω impedance to antenna jack J140. A matching network, made up

of C140-C141 and L140, is used to match the antenna impedance to the harmonic filter. This

optimizes the performance of the transmitter and receiver into the impedance presented by the

antenna, significantly improving the antenna's efficiency.

3.5

The power control circuit is a dc-coupled amplifier whose output is the dc gate bias voltage (VGG)

applied to the two stages of the RF power amplifier U110.

The output power of the transmitter is adjusted by varying the setting of the power-set DAC

contained in the ASFICcmp IC (DACG, U451 pin 6). This PWR_SET voltage is applied to

U150 pin 3.

Stage U150-2 compares the voltage drop across current sense resistor R150 to the voltage drop

across resistor R151 caused by current flow through Q150, and adjusts its output (pin 7) to maintain

equal voltages at pins 5 and 6. Thus the current flow through Q150, and hence its emitter voltage, is

proportional to the current drawn by stage U110, which is in turn proportional to the transmitter

output power. The emitter voltage of Q150 is applied to U150 pin 2, where it is compared to the

power set voltage PWR_SET at pin 3.

The output of U150 pin 1 is divided by R110 and R111 and applied as a gate voltage to the power

amplifier U110. By varying this gate voltage as needed to keep the voltages at U150 pins 2 and 3

equal, power is maintained at the desired setting. Excessive final current, for example due to

antenna mismatch, causes a lowering of the voltage at U150 pin 6, an increased voltage at pin 2,

and a lowering of the voltage at pin 1 and of the gate voltage VGG. This prevents damage to the final

stage due to excessive current.

2-5