Epson 2400 - Perfection Photo - Dpi x Product ondersteunings bulletin - Pagina 25

Blader online of download pdf Product ondersteunings bulletin voor {categorie_naam} Epson 2400 - Perfection Photo - Dpi x. Epson 2400 - Perfection Photo - Dpi x 36 pagina's. Scanning application force quits on mac os 10.4
Ook voor Epson 2400 - Perfection Photo - Dpi x: Specificatieblad (2 pagina's), Start hier Handleiding (9 pagina's), Product ondersteunings bulletin (23 pagina's), Handmatig (11 pagina's), Update (1 pagina's), Product ondersteunings bulletin (40 pagina's), Belangrijke veiligheidsinstructies (4 pagina's), Product ondersteunings bulletin (17 pagina's), Product ondersteunings bulletin (24 pagina's), Product ondersteunings bulletin (29 pagina's), Product ondersteunings bulletin (8 pagina's), Product ondersteunings bulletin (3 pagina's), Product ondersteunings bulletin (14 pagina's), Product ondersteunings bulletin (18 pagina's), Product ondersteunings bulletin (12 pagina's), Product ondersteunings bulletin (40 pagina's), Product ondersteunings bulletin (11 pagina's), Product ondersteunings bulletin (40 pagina's), Product ondersteunings bulletin (22 pagina's), Product ondersteunings bulletin (12 pagina's), Product ondersteunings bulletin (21 pagina's)

Clicking on "Refresh List" brings up this Warning window again.

Solution:

Download the patch from Epson's Support Web site at http://support.epson.com. The Installer should find the location of

your Epson Smart Panel software and install the update automatically.

Run Setup.exe and the Install wizard will find the location of Epson Smart Panel software on your hard drive and prompt

you to continue. Click "Next." The Install wizard will then finish. Click "Finish" to complete the update and exit.

To verify the patch was successful, open Epson Smart Panel and click on the Light bulb icon in the upper left-hand

corner. Select "About" from the pull-down menu. You should see v.2.01P01E (see figure below).

Start the Scan to Email Utility and run through the steps again. You will now find that your Email Program shows up as a

registered application in the Launch Assistant window (see figure below).

After you select your Email Program, it will open with a "Compose New" window and your scanned file will be attached

to the Email. Enter an email address, a subject line, and some text in the body of the mail, and then click "Send".