Epson EMP Monitor Bedieningshandleiding - Pagina 29

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Epson EMP Monitor. Epson EMP Monitor 34 pagina's. Emp monitor for projectors
Ook voor Epson EMP Monitor: Bedieningshandleiding (11 pagina's), Bedieningshandleiding (12 pagina's), Gebruikershandleiding (42 pagina's), Bedieningshandleiding (14 pagina's), Bedieningshandleiding (37 pagina's)

Pagina afdrukken

Setting the mail notification function

The mail notification function can be used to send notification messages to

preset e-mail addresses when a problem or warning occurs with a projector

that is connected to the network. By using this function, the operator can be

notified of problems with projectors even when the operator is in a different

location from the projectors.

TIP

• Up to three addressees (destinations) can be registered and

messages can be sent to all of them at once.

• If a critical problem develops with a projector which causes it to

suddenly stop working, it may not be possible for the projector to

send a message notifying an operator of the problem.

• If "Standby Mode" is set to "Network ON" or "Network

Monitoring" is set to "ON" in the projector configuration menus,

you can monitor the projector even when it is in standby mode

(when its power is turned off). s Projector's User's Guide

• On some projectors, the mail notification function can be set in the

configuration menu. When notification messages are set to be sent

in the projector's configuration menu, both the settings in the

configuration menu and settings made on EMP Monitor are

functional.

PROCEDURE

Select "Mail notification function" from the "Tool"

menu.

The "Set mail notification function" window will be

displayed.

Set the following parameters.

Mail notification

Set to "ON" to use the mail notification function.

function

SMTP server

Enter the IP address of the SMTP server.

IP address

Up to a maximum of 255 bytes can be entered.

When you change a port number of the SMTP

server, specify this port number. The default value

is "25".

You can enter a valid number from 1 to 65535.

Sender mail

Enter the sender's e-mail address. Up to a

address

maximum of 255 bytes can be entered.

Recipient

mail address 1

Specify the destination addresses for the

Recipient

notification e-mail. Up to three destinations can be

mail address 2

set. Up to a maximum of 255 bytes can be entered.

Recipient

mail address 3