Epson PowerLite 1880 Bedieningshandleiding - Pagina 39
Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Epson PowerLite 1880. Epson PowerLite 1880 47 pagina's. Operation guide - easymp monitor
Ook voor Epson PowerLite 1880: Snelle installatie (4 pagina's), Specificaties (6 pagina's)
Pagina afdrukken
Troubleshooting
Troubleshooting
Cannot connect to the projector you want to use.
Cannot connect the projector and the computer via the network.
Check
Are the computer's LAN card and the built-in LAN function
available?
Is the network cable connected correctly?
Is the network configuration screen displayed on the
projector?
Was the network adapter used selected correctly with
EasyMP Network Projection?
Is the firewall turned off, or has the firewall been
registered as an exception?
Are the connection denial functions, such as MAC
Address
g
restrictions and port restrictions, set correctly at
the access point?
Are the IP address, the subnet mask, and the gateway
address for the access point and the projector set
correctly?
Are the access point and the projector's subnet different? Select Manual search from EasyMP Network Projection, specify the IP address, and connect.
Have you enabled DHCP?
Check that LAN is available from the device manager under Control Panel - System - Hardware.
Check that the network cable is connected correctly. Reconnect it if it is not connected or not
connected properly.
Close network settings on the projector, and return to the LAN standby screen. If the network
configuration screen is displayed on the projector, you cannot connect using EasyMP Network
Projection.
If the computer has multiple LAN environments, it cannot connect unless the network adapter is
selected correctly. When using a computer running Windows, start EasyMP Network Projection and
select the network adapter you are using from Set options - Switch LAN.
When you do not wish to turn off the firewall or register the firewall as an exception, make the
necessary settings to open the ports.
The ports used by EasyMP Network Projection are "3620", "3621", and "3629".
Set connection permission at the access point to allow projectors to connect.
When not using a DHCP, adjust each setting.
You can make the DHCP setting from the projector's Network menu.
See your projector User's Guide for details.
When DHCP is set to On, it may take some time to enter LAN standby status if an available DHCP
server is not found.
Remedy
39