Epson PowerLite 61p Productinformatie - Pagina 13

Blader online of download pdf Productinformatie voor {categorie_naam} Epson PowerLite 61p. Epson PowerLite 61p 15 pagina's. Release of emp ns connection for windows & mac upgrade from v2.50 to v2.51
Ook voor Epson PowerLite 61p: Gebruikershandleiding (42 pagina's), Specificaties (2 pagina's), Bedieningshandleiding (47 pagina's), Handleiding voor snelle installatie (2 pagina's), Onderdelenlijst (1 pagina's), Lamp vervanging update (2 pagina's), Installatiehandleiding (19 pagina's), Product ondersteunings bulletin (25 pagina's), Product ondersteunings bulletin (8 pagina's), Product ondersteunings bulletin (22 pagina's), Product ondersteunings bulletin (28 pagina's), Product ondersteunings bulletin (41 pagina's), Product ondersteunings bulletin (15 pagina's), Product ondersteunings bulletin (22 pagina's)

5. Use the screwdriver to loosen the two screws holding the

lamp in place. (You can't remove the screws.)

6. Hold the lamp as shown and pull it straight out.

Warning:

This product includes a lamp component that contains mercury

(Hg). Please consult your state and local regulations regarding

disposal or recycling. Do not put it in the trash.

7. Gently insert the new lamp. If it doesn't fit easily, make sure

it's facing the correct way.

8. Once the lamp is fully inserted, tighten its screws.

Caution:

Do not touch the glass portion of the lamp assembly. Touching

the glass could result in premature lamp failure.

Don't remove

these screws

Epson PowerLite 61p/81p Projector

9. Lower the lamp cover into place. (The opening should be

almost covered, and the top of the lamp cover should be

flush with the surface of the projector.) Then slide the cover

closed and tighten the screw.

10.Reset the lamp timer as described in the next section.

Resetting the Lamp Timer

You must reset the lamp timer after replacing the lamp to clear

the

Replace the Lamp

Note:

Do not reset the lamp timer if you have not replaced the lamp. If

you do, the

Lamp Hours

hours that the lamp has been used.

1. Connect the power cable and turn on the projector.

2. Press the

button on the remote control and select the

menu. Then press

Reset

3. Select

Lamp-Hours Reset

following:

6/04

Epson PowerLite 61p/81p Projector

message.

will not accurately reflect the number of

. You see the following:

Enter

and press Enter. You see the