Epson PowerLite D6155W Handleiding voor snelle installatie - Pagina 2

Blader online of download pdf Handleiding voor snelle installatie voor {categorie_naam} Epson PowerLite D6155W. Epson PowerLite D6155W 4 pagina's. Air filter and vent maintenance
Ook voor Epson PowerLite D6155W: Brochure (6 pagina's), Bedieningshandleiding (50 pagina's), Conformiteitsverklaring (4 pagina's), Onderhoudshandleiding (4 pagina's), Installatie Handboek (4 pagina's), Installatie Handboek (4 pagina's), Installatie Handboek (3 pagina's)

Epson PowerLite D6155W Handleiding voor snelle installatie

Adjust the image

1
If you don't see an image, press the Source Search button on the
projector or the remote control to select the image source.
Note: If you still see a blank screen or have other display problems, see
the troubleshooting tips on the back of this sheet.
2
To raise the image, press the foot release button and lift the front of the
projector. Release the button to lock the foot in position.
3
Open the zoom/focus ring cover and rotate the focus ring to sharpen the
image.
Zoom/focus ring 
cover
Focus ring
4
Turn the zoom ring to reduce or enlarge the image.
Zoom ring
5
If your image looks like
one side of the screen at an angle. Place it directly in front of the center
of the screen, facing the screen squarely. Or press the
the projector to correct it.
6
If your image looks like
or
projector to correct it.

Using the remote control

Make sure the batteries are installed as shown (two AA batteries).
Turn projector 
on and off
Turn off projector 
display and sound
Access projector 
menus
For more information on using the remote control, see the User's Guide on your
projector CD.
or
, you've placed the projector off to
or
buttons on
, press the
or
buttons on the
Choose which source 
to display
Control projector 
volume
Navigate projector 
menus
Project over a wired
network
Follow the steps here to configure your projector for your wired network
using the projector's menu system.
1
Plug in and turn on the projector.
2
Press the Menu button on the remote control, select the Network
menu, and press Enter.
3
Select Network Configuration and press Enter.
4
Select the Basic menu and press Enter.
5
Select the Projector Name setting and enter a name (up to 16
characters long) to identify your projector over the network.
Use the displayed keyboard to enter characters. Press the arrow buttons
on the remote control to highlight the characters and press Enter to
select them.
Note: See the User's Guide on the projector CD for information on
adding passwords.
6
Select the Wired LAN menu and press Enter.
7
Choose IP Settings and press Enter.
8
If your network assigns addresses automatically, select IP Settings and
turn on the DHCP setting. If not, turn off the DHCP setting and enter
the projector's IP Address, Subnet Mask, and Gateway Address,
as needed.
9
To prevent the IP address from appearing on the network standby
screen, set the IP Address Display setting to Off.