Epson Stylus Pro 10000 Series Gebruikershandleiding - Pagina 6

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Epson Stylus Pro 10000 Series. Epson Stylus Pro 10000 Series 13 pagina's. Auto take-up reel unit
Ook voor Epson Stylus Pro 10000 Series: Specificaties (6 pagina's), Productinformatie (16 pagina's), Installatiehandleiding (26 pagina's), Snelle installatiehandleiding (34 pagina's), Snelle referentiehandleiding (12 pagina's), Garantie (28 pagina's), Snelle referentiehandleiding (12 pagina's), Specificaties (4 pagina's), Specificaties (1 pagina's), Montagehandleiding (12 pagina's)

Installing the sensor unit

The sensor components are shown below.

Light detector

Connector

1. Set the sensor unit's light emitter in the bottom

of the drive unit, and then secure it with a

screw.

2. Set the sensor unit's light detector in the base

unit's bottom left side, and then secure it with

a screw.

Downloaded from:

http://www.usersmanualguide.com/

3. Plug the connector of the sensor unit cable into

Light emitter

4. Fasten the cable using the cable clamps

the socket located at the top rear of the control

box on the drive unit.

provided. Use as many of the clamps as

necessary to secure the cable.You may need to

do this from the back of the printer.