Philips WT121XES Gebruikershandleiding - Pagina 29

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Philips WT121XES. Philips WT121XES 36 pagina's. Applied rfid

12.0.0 TROUBLESHOOTING

12.1.1 THE ProScribe WILL NOT TURN ON...

• Make sure that both the battery latches on the back of the unit are set to the lock position.

• When power is on, you will see:

On the pad: Power indicator light above the screen on the right will turn green

• If power is on, but you still don't see anything on the screen, wake up the pad by tapping on the screen or by pressing

control buttons located on the right hand side of the screen.

• If pad does not power on attach the AC adapter to the unit by either ;

Plugging the AC adapter into the DC in jack located under the protective flap on the right hand side of the

unit, making sure that the Adapter is also plugged into the wall socket.

• If the preceding steps do not turn the pad on, try restarting the machine:

As a last resort remove the power cord and the battery, wait ten seconds then insert again the battery and power

cord, try to switch ON the ProScribe

12.2.1 My SySTEM DOES NOT RUN SMOOTHLy

Poor wireless signal quality or the simultaneous opening of too many applications will cause deterioration in application

performance.

To free up memory, close applications that are not in use.

Check wireless signal quality:

• WLAN LED indicator. When the WLAN LED indicator is green, a wireless signal is available. A blinking LED indicates

a weak or unstable signal. When no signal is available, the LED is amber. If signal is weak, try moving closer to your

Access Point, or try repositioning the antenna of the access point.

• Network icon. Double tap the Network icon on the bar at the bottom of the screen. Choose the Wireless Information

tab to show the current connection.

12.3.1 HOW DO I TURN OFF My ProScribe

To end operation: Press the power switch on the upper right side.

Or tap the "START Menu" and then choose "Shut Down" to turn off the pad.

NOTE:

Pressing the Power switch of the device for more then five seconds will make an hard turn Off preventing the Operating

System to perform the correct shutdown procedure.

12.4.1 WHEN I USE THE STyLUS PEN...

• System does not respond to taps...

Try tapping the center of an icon.

Re-calibrate the tapping pattern.

NOTE:

You might need to practice a couple of time in to operate your screen with taps.

• The mouse arrow is out of alignment...

The mouse arrow does not point to the center of icon as you intend. It might be due to the viewing angle or the stylus

may require calibration.

• Users accustomed to a mouse device use a right click for quick access to command options of an object.

The stylus pen offers a similar command function. Here's how: See parag. 7..1

12.6.1

• Open the on-screen keyboard. You can use the Input Panel button to open up the on-screen keyboard. This

button is located at the lower right side of the pad.

WT11