Philips AZ102C Gebruikershandleiding - Pagina 15

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Philips AZ102C. Philips AZ102C 18 pagina's. Cd soundmachine
Ook voor Philips AZ102C: Specificaties (2 pagina's), Gebruikershandleiding (15 pagina's), Gebruikershandleiding (14 pagina's), Specificaties (2 pagina's), Gebruikershandleiding (2 pagina's), Gebruikershandleiding (2 pagina's), Gebruikershandleiding (15 pagina's), Gebruikershandleiding (2 pagina's), Gebruikershandleiding (13 pagina's), Specificaties (2 pagina's), Gebruikershandleiding (1 pagina's), Servicehandleiding (11 pagina's)

Pagina afdrukken
Philips AZ102C Gebruikershandleiding

Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Problem
– Possible cause
• Remedy
No sound /power
– Volume not adjusted
• Adjust the VOLUME
– Power cord not securely connected
• Connect the AC power cord properly
– Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
– CD contains non-audio files
• Press ∞ , § once or more to skip to a CD audio
track, instead of the data file.
Display does not function properly / No
reaction to operation of any of the
controls
– Electrostatic discharge
• Switch off and unplug the set. Reconnect after a
few seconds
Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
--, Er or 01 indication
– No CD inserted
• Insert a CD
– CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
– Laser lens steamed up
• Wait until lens has cleared
– CD-R/CD-RW is blank or not finalized
• Use a finalized CD-R/CD-RW or suitable CD
Audio disc only
Note:
Make sure the CD is not encoded with copy-
right protection technologies, as some do not
conform to the Compact Disc standard.
The CD skips tracks
– CD damaged or dirty
• Replace or clean CD
– Program/shuffle is active
• Quit program/shuffle mode
Note: A CD badly scratch or dirty may result in
improper operation.