Philips AZ700T Snelstarthandleiding - Pagina 2
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Philips AZ700T. Philips AZ700T 2 pagina's.
Ook voor Philips AZ700T: Gebruikershandleiding (24 pagina's), Gebruikershandleiding (21 pagina's)
Pagina afdrukken
MUTE
BT
USB
AUDIO IN
CD
TUNER
PAIRING
REPEAT
ALBUM/
PRESET
SHUFFLE
DSC
DBB
SLEEP
PROG
BACKLIGHT
MUTE
BT
USB
AUDIO IN
CD
TUNER
PAIRING
REPEAT
ALBUM/
PRESET
SHUFFLE
DSC
DBB
SLEEP
PROG
BACKLIGHT
BT
MUTE
USB
AUDIO IN
CD
TUNER
PAIRING
MUTE
BT
USB
AUDIO IN
CD
TUNER
PAIRING
REPEAT
ALBUM/
PRESET
SHUFFLE
REPEAT
ALBUM/
PRESET
SHUFFLE
DSC
DBB
DSC
DBB
SLEEP
PROG
SLEEP
PROG
BACKLIGHT
BACKLIGHT
V4.2
120V~60Hz;
100
V4.2
120V~60Hz;
100
V4.2
120V~60Hz;
100
MUTE
BT
USB
AUDIO IN
CD
TUNER
PAIRING
REPEAT
ALBUM/
PRESET
SHUFFLE
DSC
DBB
SLEEP
PROG
BACKLIGHT
1.
To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
2.
A warning that batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
3.
where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable
CLASS 1 LASER PRODUCT
4.
Complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to Laser Notice No.50, dated June 24, 2007
MMD Hong Kong Holding Limited Units 1006-1007,10th Floor, C-Bons International Center,108 Wai Yip Street, Kwun Tong, Kowloon,
Hong Kong
FCC Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
ISED Regulatory Compliance
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development
Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1 )This device may not cause
interference.(2)This device must accept any interference, including interference that may cause undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes :(1)L'appareil ne doit pas produire de brouillage; (2)L'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
RF Exposure Compliance
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter.
ce matériel est conforme aux limites de dose d'exposition aux rayonnements FCC/IC énoncées pour un autre environnement.cet émetteur
ne doit pas être situées ou opérant conjointement avec toute autre antenne ou l'émetteur.