Philips DCD7010 Gebruikershandleiding - Pagina 12
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Philips DCD7010. Philips DCD7010 28 pagina's. Dvd component hi-fi system
Ook voor Philips DCD7010: Snelstarthandleiding (1 pagina's), Gebruikershandleiding (28 pagina's), Brochure (3 pagina's), Specificaties (3 pagina's)
Pagina afdrukken
Connect power
Note
•
Where the MAINS plug or an appliance coupler
is used as the disconnect device, the disconnect
device shall remain readily operable.
•
Risk of product damage! Make sure that the
power supply voltage corresponds to the
voltage printed on the back of the MAIN plug.
•
Before you connect the AC power cord, make
sure that you have complete all other connections.
•
Protect the power cord from being walked on
or pinched, particularly at plugs, convenience
receptacles, and the points where they exit
from the apparatus.
•
Unplug this apparatus during lightning storms
or when unused for long periods of time.
Install/replace the battery of
remote control
a Push to open the battery compartment
cover.
b Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
c Close the cover.
Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
•
Do not mix batteries (old and new or carbon
and alkaline, etc).
•
Remove the battery if the remote control is
not to be used for an extended period of time.
12
EN
4 Get started
Turn on
1
Press .
» The unit switches to the last selected
source.
Note
•
If no source is played within 15 minutes, the
unit switches to standby mode.
•
If no operation is performed within 15 minutes
in standby mode, the unit switches to Eco-
power standby mode.
•
Press
to switch the unit to the last source
when it was turned off.
Demonstrate the unit's features
1. In the standby mode, press
DEMO mode
» This system's features are displayed
one by one.
•
To turn off the demonstration, press
again.
Set the clock
The unit uses the 24-hour or 12-hour time
format.
1
In standby mode, press and hold CLOCK
for 2 seconds.
» "CLOCK SET" scrolls on the display.
Then the time format [24H] or [12H]
appears.
2
Press VOL +/- to select a time format.
Press CLOCK to confirm.
» The hour digits blink.
3
Press VOL +/- to set the hour. Press
CLOCK to confirm.
» The minute digits blink.
4
Press CLOCK to confirm the setup.
to turn on