Philips Expanium AZ 1538 Handmatig - Pagina 9
Blader online of download pdf Handmatig voor {categorie_naam} Philips Expanium AZ 1538. Philips Expanium AZ 1538 13 pagina's. Cd sound system
Ook voor Philips Expanium AZ 1538: Gebruikershandleiding (2 pagina's), Specificaties (2 pagina's), Servicehandleiding (31 pagina's)
Pagina afdrukken
TROUBLESHOOTING
WARNING:
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
No sound /power
– Volume not adjusted
• Adjust the VOLUME
– Mains lead not securely connected
• Connect the AC mains lead properly
– Batteries exhausted/ incorrectly inserted
• Insert (fresh) batteries correctly
– Headphones connected to the set
• Disconnect headphones
-- CD contains non-audio files
• Press SEARCH ∞ or §. once or more to skip to a
CD audio track, instead of the data file
Severe radio hum or noise
– Electrical interference: set too close to TV, VCR or
computer
• Move the set to increase the distance
Poor radio reception
– Weak radio signal
• FM: Adjust the FM telescopic aerial
noPr indication
– During programming radio preset stations, you have
keyed in a preset number that exceeds the maximum
preset number i.e. 40
• Key in a preset number from 1-40
nOdISc
or bad
dIScindication
– CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
– Laser lens steamed up
• Wait until lens has cleared
nFdISc indication
– CD-R(W) is blank/ not finalized
• Use a finalized CD-R(W)
Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
dAtA indication
– blank disc/ disc contains data files
• Use a suitable CD recorded with audio/ .mp3 files
Err dAtA indication
– Difficulty reading files
• Turn off the set, then switch on again. Or change to
tuner function. Then return to CD function and
playback.
Sound skips during MP3 playback
-- MP3 file made at compression level exceeding
320kbps
• Use a lower compression level to record CD tracks
into MP3 format
Cannot find desired MP3 title
-- Wrong file extension used and/ or file name with
unsuitable text characters used
• Make sure the file names are typed in English text
characters an that the MP3 files end with .MP3
The CD skips tracks
– CD damaged or dirty
• Replace or clean CD
– SHUFFLE or PROGRAM is active
• Switch off SHUFFLE / PROGRAM
Remote control does not function properly
– Batteries exhausted/ incorrectly inserted
• Insert (fresh) batteries correctly
– Distance/ angle between the set too large
• Reduce the distance/ angle