Toshiba TLP-ET1U Gebruikershandleiding - Pagina 19
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Toshiba TLP-ET1U. Toshiba TLP-ET1U 50 pagina's. 3lcd projector
Turning the power off
Note
• The projector consumes about 1 W (AC 100 - 120 V) or 3 W (AC 220 - 240 V) of power in standby. You should
unplug the power cord if you will not use the projector for an extended period.
PRECAUTIONS
• Before unplugging the power cord, make sure that the LAMP indicator is off. Unplugging the power cord to cut
off the power while the projector is running or being cooled will shorten the life of the lamp. However, please
unplug the power cord if the projector locks up or acts abnormally.
• If the power cord was unplugged before cooling was completed, give the lamp sufficient time to cool down
before plugging it back in. If the lamp overheats, it may fail to light, and its lifetime will be shortened.
• Before turning the power off, turn down the volume if possible.
Press the ON/STANDBY button.
Remote control Control panel
Press the ON/STANDBY button again.
Remote control Control panel
Cooling in progress
ON
LAMP
TEMP
FAN
(Orange) (Green)
(Green)
Flashing
Cooling completed
ON
LAMP
TEMP
FAN
(Orange) (Off)
(Off)
A message appears on the screen,
confirming that you wish to shut off the
power. This message will disappear after
a moment. (This operation is no longer valid
after the message disappears.)
The screen is turned off, but the internal
cooling fan continues to operate for a short
while. Then, the projector goes into standby
mode.
During cooling, the LAMP indicator flashes.
In this state, the power cannot be turned
back on. In addition, unplugging the power
cord in this state will shorten the life of the
lamp.
The LAMP and FAN indicators go off, and
the projector goes into standby mode.
19