AEO WP401209 Gebruikershandleiding
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AEO WP401209. AEO WP401209 2 pagina's. Solar dc water pump
Pagina afdrukken
AEO-WP401209 SOLAR DC WATER PUMP
USER'S MANUAL
Brushless Submersible, 12V-24V, 196GpH
for Solar Fountain, Hydroponics and Aquaponics
Place the Water Pump under water BEFORE connecting to a power source.
The water pump may become damaged if it is not under water before
powering it on.
The plugs on the DC Short Connector (3) and power cable connected to the
Water Pump (1) must match in polarity (+ -). Connect the two plugs by
matching the flat sides. (See figure in Section 2.3)
This is a DC (Direct Current) water pump. DO NOT connect to any AC power.
Water Pump can be powered by a 12V-24V DC battery; however, when
connects to a Solar Panel, an 18V Solar Panel is recommended, because a
24V solar panel actual output will exceed its nominal voltage when sunlight
at highest intensity.
Please carefully read this user manual before installing the pump.
Section 1: INCLUDED
(1) Water Pump
(2) Nozzles
(3) DC Short Connector
Section 2: CAUTIONS
1)
Make sure the water pump is fully submerged underwater while it is
operating.
2)
Do not connect the pump to any AC power supply; it is designed
ONLY for DC power between 12V to 24V. When connects to a Solar
Panel, an 18V Solar Panel is recommended, because a 24V solar panel
actual output will exceed its nominal voltage when sunlight at highest
intensity.
3)
The polarity of the power
cable plug on the Water
Pump (1) must match the
plug on the DC Short
Connector (3) as shown in
the figure to the right.
Connect the two plugs by
matching the flat sides; do
not force them together.
4)
Any alteration of the product itself or changing of the components
voids warranty.
5)
Operate the pump in water only (under 104°F), and keep it away from
flammable liquids.
Section 3: ASSEMBLY
*Unpack all components carefully.
1)
[Setup Water Pump]
a) Connect the nozzles tubes (adjust the height by the number of
tubes) to the water pump outlet to produce a fountain effect
above the surface of the water. Use a taller base such as bricks or
marble slabs if the cylinder is not high enough.
b) Connect one of the fountain heads on top of cylinder tubes for
different water patterns.
c) Place the water pump under the water (fish tank, small pond, etc.),
but on top of a base such as a brick or marble slab to prevent dirt,
mud, or sand from getting into the filter. For deep water, the AEO
Floating Pad is recommended and can be found on Amazon.com
by searching for "AEO Floating Pad".
2)
[Connect the Water Pump to DC Short Connector]
plugs between the power cable and DC Short Connector (3). The plugs
must match in polarity (+ -). Connect the two plugs by matching the
flat sides. (See figure in Section 2-3)
connecting the