3Com 8500 Snelstarthandleiding - Pagina 4

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} 3Com 8500. 3Com 8500 8 pagina's. Wireless lan access point
Ook voor 3Com 8500: Gegevensblad (4 pagina's), Gegevensblad (4 pagina's), Snelstarthandleiding (10 pagina's)

Pagina afdrukken

To link the access point to your Ethernet network, plug one end of another Ethernet cable into

the port labeled To Hub/Switch on the power supply, and plug the other end into a LAN port

(on a hub or in a wall).

CAUTION: To avoid damaging network equipment, make sure that the cables are connected

from access point to power supply to LAN as shown and described above.

Using a Power-Over-Ethernet LAN Port

If your LAN equipment complies with the IEEE 802.3af power-over-Ethernet standard, you can connect the

access point directly to a LAN port. For example, the illustration above right shows a connection through a

3Com Ethernet Power Supply to a 3Com SuperStack

Check the LEDs

When power is connected, the access point LEDs light. The illustration and the following table describe the

LEDs and their functions.

Wall Mount Installation

Install the mounting plate as shown in the following illustration, on either a stud (or other

hard wall surface), or onto drywall.

If installing into a stud or other

secure vertical surface, use 2 screws.

Name

Radio

Power

Reset

Button

Ethernet

Radio

Switch.

Description

LED blinks red to indicate radio activity. Faster blinking

indicates more activity.

LED lights green when operational code is running.

Press this button in for 15 seconds to restore the factory

defaults.

LED lights yellow when Ethernet link is established. LED

blinks to indicate activity on the Ethernet. Faster blinking

indicates more activity.

LED blinks red to indicate radio activity. Faster blinking

indicates more activity. This LED is only active when a

second radio is installed.

If installing into drywall, use

3 plastic anchors and 3 screws.