3Com LANplex 6000 Installatiehandleiding - Pagina 4

Blader online of download pdf Installatiehandleiding voor {categorie_naam} 3Com LANplex 6000. 3Com LANplex 6000 16 pagina's. 11 mbps wireless lan access point 6000
Ook voor 3Com LANplex 6000: Gegevensblad (2 pagina's)

Pagina afdrukken

TRSM Installation

This section describes the following:

Module safety information

Installation information

LED activity during installation

Pin-out information

Information on installing modules is also included in the LANplex 6000

Getting Started guide.

Safety Information

Electrostatic discharge (ESD) damage occurs when the module is improperly

handled. ESD can damage components on a module, causing complete or

intermittent failures.

To prevent ESD-related damage, handle the module in the following

manner:

Always wear the ESD wrist strap provided with the module, ensuring that it

makes good skin contact and that the alligator clip is connected to a

suitable ground. See Figure 3 on page 7.

Keep the module in its antistatic shielded bag until you are ready to

install it.

Do not touch the components, pins, leads, or solder connections.

Always handle the module by its edges.

Additionally, you should cover every empty slot with a blank faceplate to

protect the system from dust or other foreign substances, and to ensure

proper system cooling.

Prior to Installation

Before you install your new module, follow the appropriate pre-installation

instructions below:

Your LANplex system is shipped with no modules installed and with

Read if installing in

an empty slot

protective faceplates covering the installation slots. Initial installation

requires that you remove the protective faceplate covering the selected

installation slot prior to installing the option module.