Dimplex DLG1106 Gebruikershandleiding - Pagina 12

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dimplex DLG1106. Dimplex DLG1106 16 pagina's. Log grate
Ook voor Dimplex DLG1106: Servicehandleiding (9 pagina's)

Pagina afdrukken

Operation

Remote Control Initialization/

Reprogramming

Follow these steps for remote

control initialization and if

required, re-initialization:

Ensure that power is supplied

through the main service

panel.

Turn on/off switch to off

(Figure 1a).

Wait a minimum of five (5)

seconds and then re-acquire

power to log grate.

Within 10 seconds of re-

acquiring power, press the

on button located on the

remote control. (Figure 2)

This will synchronize the remote

control and receiver.

Remote Control Usage

The remote control operates the

fireplace by toggling between

logs and light only to logs, lights

and heat, using the on button on

the remote control. The fireplace

can be turned off at any point by

pressing the oFF button on the

remote control.

Level 1: The logs and lights are

turned on.

Level 2: The logs and lights

remain on and the heater is

activated.

Figure 2

Button

off

Button

Battery

Cover

NOTE: When fireplace is

turned on by remote control the

fireplace will start with flames

only. The level can be increased

every time the on button on the

remote control is pressed.

Battery Replacement

To replace the battery:

slide battery cover open on

the remote control (Figure 2).

Install one (1) 12-Volt (a23)

battery in the battery holder.

Close the battery cover.

Battery must be recycled

or disposed of properly.

Check with your Local

authority or Retailer for recycling

advice in your area.