Aeon Labs Minimote Handmatig - Pagina 4

Blader online of download pdf Handmatig voor {categorie_naam} Aeon Labs Minimote. Aeon Labs Minimote 7 pagina's. Z-wave remote controller
Ook voor Aeon Labs Minimote: Handmatig (7 pagina's)

Pagina afdrukken

Shift Primary Role to a different Controller

The device can hand over its primary role to another controller and become secondary controller.

The primary shift is initiated on the device by pressing the "Learn" button.

Set association between two device in Z-Wave network

The controller is able to set association between two other devices in the network. The controller is turned into an association

mode both devices are announced by pressing a button. After both association partners are known the controller will perform all

necessary steps to set the association.

Press "Association" button

Issue a Node Information Frame from the target device. This is usually done by single or triple click a button. Please refer to the

manual of this device how to issue a NIF.

Issue a Node Information Frame from the device where the association will be set. This is usually done by single or triple click a

button. Please refer to the manual of this device how to issue a NIF.

Update Network Information

As a battery operated controller the device will not automatically received updates about the network structure. This process

should be initiated when the primary controller has included/excluded devices and it will result in an update of the network

information in the battery operated controller. This prevents wrong communication that may cost battery life and delay other

communication.

Press the button "Association" for 10 seconds to update the network.

it is possible that a network update fails if the network was changed too much after the last update. In this case the the device

need to be reincluded. Re-Inclusion is similar to a normal inclusion. Its just not needed to exclude the device before. Re-Inclusion

makes sure that the node ID of the device remails unchanged.

Reset the Controller

Press the buttons "Association" and "Learn" together for 10 seconds to reset the device.

Configuration Parameters

Z-Wave products are supposed to work out of the box after inclusion, however certain configuration can adapt the function better

to user needs or unlock further enhanced features.

IMPORTANT: Controllers may only allow configuring signed values. In order to set values in the range 128 ... 255 the value sent in

the application shall be the desired value minus 256. For example: to set a parameter to 200 it may be needed to set a value of

200 minus 256 = minus 56. In case of a two byte value the same logic applies: Values greater than 32768 may needed to be given

as negative values too.

Mode of Button 1 (upper left) (Parameter Number 241, Parameter Size 1)

Button 1

Value

Description

Factory Default (Default)

Scene Mode

Add Mode

Remove Mode

Association Mode

Defines the switching mode of