Aeon Labs AEO HEM2-100A Snelstarthandleiding - Pagina 3

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Aeon Labs AEO HEM2-100A. Aeon Labs AEO HEM2-100A 11 pagina's. Z-wave clamp power meter 2nd generation - two clamps max. 100 ampere

Pagina afdrukken

The installation of your Aeotec Home Energy Meter has two major parts: the installation of the meter into

your Z-Wave network, and the installation of it into your AC mains electricity box. The electrical installation

of your meter into your circuit box should only be done a licensed electrician with knowledge and

understanding of electrical systems and electrical safety. You can perform the second half of the installation

process, linking the meter with your Z-Wave network, yourself.

Important: Turn the main breaker off and open the main circuit box panel.

Clip clamps of the meter around the incoming electricity cables that connect to the main circuit breaker.

Connect the clamp to the meter using a Clamp Connector.

Connect the AC Wire to the meter using the AC Wire Connector.(option)

Insert one of AC Power exposed wires into one of the neutral bus terminals and the other exposed wire into

the live terminals coming from the main circuit breaker.

Replace the main circuit box panel.

Turn the main breaker back on.

If the circuit boxes is made of metal the radio signal strength may be reduced. In this situation it is

recommended that the main body of the meter be affixed outside the circuit box. This will improve the radio

signal strength. The Home Energy Meter G2 has been weatherized to the international IP44 standard so

that it is resistant to rain and snow when placed vertically with the wires protruding from the bottom of the

unit.

To place the Home Energy Meter:

Slip open the backing plate from the back of your meter.

Affix the plate to the selected wall space using the provided screws.

Attach your meter to the backing plate.

After an electrician connects your Home Energy Meter to your electrical mains, you should include the meter

into your Z-Wave network.

Behavior within the Z-Wave network

On factory default the device does not belong to any Z-Wave network. The device needs to join an

existing wireless network to communicate with the devices of this network. This process is called Inclusion.

Devices can also leave a network. This process is called Exclusion. Both processes are initiated by the

primary controller of the Z-Wave network. This controller will be turned into exclusion respective inclusion

mode. Please refer to your primary controllers manual on how to turn your controller into inclusion or

exclusion mode. Only if the primary controller is in inclusion or exclusion mode, this device can join or leave

the network. Leaving the network - i.e. being excluded - sets the device back to factory default.

If the device already belongs to a network, follow the exclusion process before including it in your network.

Otherwise inclusion of this device will fail. If the controller being included was a primary controller, it has to

be reset first.

Single click the little button on the backside one time to include or exclude the device.

Aeon Labs AEO HEM2-100A Snelstarthandleiding - Pagina 3

Behavior within the Z-Wave network

Operating the device