DimSport RapidBike EVO Handleiding voor installatie-instructies - Pagina 2

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} DimSport RapidBike EVO. DimSport RapidBike EVO 12 pagina's.

Pagina afdrukken

___________________________ Installing instructions

Attention: For a correct RB feeding voltage, check the operation of all motorbike

electrical system components (lights, fuse, stock connectors, etc.).

1. Turn off the engine.

2. Remove the main seat and the fuel tank.

____________________________ Injection section ___________________________

3. Locate and disconnect the 2 way connector of the front cylinder's injector.

4. Connect Rapid Bike connectors marked as INJECTOR 1 in-line of the stock

harness.

5. Locate and disconnect the 2 way connector of the rear cylinder's injector.

6. Connect Rapid Bike connectors marked as INJECTOR 2 in-line of the stock

harness.

WARNING: In case the harness has one couple of 6-way connectors marked as

"INJECTORS", then follow the instructions at the bottom of this manual (Page 9).

Issued by: PM

approved by DG

______________________________

Rev.07

date 01/03/16

pag. 2/12