Pioneer AVIC-80DVD Servicehandleiding - Pagina 32

Blader online of download pdf Servicehandleiding voor {categorie_naam} Pioneer AVIC-80DVD. Pioneer AVIC-80DVD 35 pagina's. 2004 mobile entertainment systems
Ook voor Pioneer AVIC-80DVD: Hardware Handleiding (16 pagina's), Gebruikershandleiding (24 pagina's)

Pagina afdrukken
Pioneer AVIC-80DVD Servicehandleiding
1
QQ
3 7 63 1515 0
Symptoms that can occur if proper adjustments are not made: Error rate reaches 10 (10 or less under normal condi-
A
tions).
The RF jitter becomes more pronounced - the RF waveform becomes deformed.
Retraction of the tracking and the servo motor, become unstable.
Cautions for performing adjustments: Do not look directly into the laser beam for any prolonged periods of time.
Procedure:
1. Replace the cable, connecting the product's main unit and the DVD mechanical module, with a 40-pin extended flex-
ible cable (GGD1170), and turn the DVD mechanical module upside down, in order to proceed with pick-up unit adjust-
ments.
2. Remove adhesive materials from the pick-up unit, using tweezers.
(Note) Make sure that adhesive material fragments are not scattered while removing the adhesive from the unit. Be
also very careful not to exert excessive force on the actuator.
3. Connect the unit to an oscilloscope, referring to the connection diagram.
B
4. Turn the product power ON, and load the disk for adjustments (GGV1018).
5. Set the disk type to single-layer DVD in the front-end test mode, turn the power ON and then move the pick-up to
the middle radius.
6. LD ON.
7. Close in the focus(Do not carry out 'T.Bal adjustment' and 'Tracking close'.)
8. Maximize the level by slightly turning the skew adjustment screw A, while looking at the RF waveform level on the
oscilloscope.
Next, maximize the level by turning the skew adjustment screw B, slightly. Repeat this procedure three times and
adjust the unit to attain a maximum level.
9. Turn the power OFF in the test mode, and eject the disk after verifying that it has stopped spinning.
10. Apply adhesive and screw lock materials, to the locations specified in the pick-up diagram (shown below).
C
Apply the adhesive material to secure the resin components on the pick-up chassis.
Apply the screw lock material to secure the screws on the pick-up chassis.
Do not apply any of these materials to the pick-up section or mechanical sections, which are not specified.
Keep the unit away from vibration or shock until the materials securely fix the components and screws in place.
TE
L 13942296513
PU diagram
Skew adjustment screw A
D
Screw rock(GYL1001)
E
www
F
32
1
http://www.xiaoyu163.com
2
Adhesive material
(GEM1033)
x
ao
y
.
i
AVIC-80DVD/UC
2
http://www.xiaoyu163.com
3
8
Q Q
3
6 7
1 3
Skew adjustment screw B
Screw rock(GYL1001)
u163
.
3
4
2 9
9 4
2 8
-3
-4
1 5
0 5
8
2 9
9 4
m
co
4
9 9
2 8
9 9