Pioneer A-209 Gebruiksaanwijzing - Pagina 11
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Pioneer A-209. Pioneer A-209 32 pagina's. Stereo amplifier
Ook voor Pioneer A-209: Catalogus (10 pagina's), Servicehandleiding (35 pagina's)
Pagina afdrukken
TROUBLESHOOTING
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component,
check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical
appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center
or your dealer to carry out repair work.
Symptom
No power supplied to unit.
No sound.
No sound from one speaker.
Cannot record tapes.
Cannot perform tape copy-
ing.
Abnormal functioning of this unit may be cased by, static electricity, or other external interference. To restore normal operation, turn
the power off and then on again, or unplug the AC power cord and then plug it in again.
Cause
÷ Power plug is disconnected from outlet.
÷ The amplifier's power plug has been plugged
into another component's power outlet (e.g.
timer, etc.) but power to that unit is discon-
nected.
÷ The AC INLET plug is disconnected.
÷ Connecting cords are disconnected from ter-
minals, or connected incorrectly.
÷ Terminals, or connecting cords pin plugs are
dirty.
÷ The TAPE 2 MONITOR button is set to ON
(except when using an adaptor component).
÷ Operation of other components is incorrect.
÷ The position of the INPUT SELECTOR does
not match the component to be played back.
÷ Both SPEAKERS selector buttons are set to
OFF (A-209 only).
÷ SPEAKERS button is set to OFF (A-109 only).
÷ Connecting cords or speaker cords are discon-
nected on that side.
÷ BALANCE control is set to one side.
÷ Connections are incorrect.
÷ Operation of cassette deck is incorrect.
÷ The TAPE 2 MONITOR button is set to ON.
÷ The position of the INPUT SELECTOR knob
and TAPE 2 MONITOR button are incorrect
(when using 2 cassette decks).
÷ Operation of cassette decks is incorrect.
Remedy
÷ Insert plug securely into outlet.
÷ Turn on power to other component.
÷ Insert the AC INLET plug securely till the
bottom of the jack.
÷ Connect securely.
÷ Clean terminals and plugs.
÷ Set the button to OFF.
÷ Consult the operating instructions for
the other components.
÷ Set the button correctly (CD, TUNER,
PHONO, LINE, TAPE 1/CD-R/MD).
÷ Set one button or both buttons to ON (A-
209 only).
÷ Set the button to ON (A-109 only).
÷ Connect securely.
÷ Set BALANCE control to center posi-
tion.
÷ Reconnect properly.
÷ Consult the operating instructions for
the cassette deck.
÷ Set the TAPE 2 MONITOR button to
OFF.
÷ Set buttons correctly. (See section
COPYING TAPES.)
÷ Consult the operating instructions for
the cassette decks.
11