Pioneer F-208 Gebruiksaanwijzing - Pagina 4

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Pioneer F-208. Pioneer F-208 34 pagina's. Fm/am digital-synthesizer tuner
Ook voor Pioneer F-208: Catalogus (10 pagina's), Servicehandleiding (21 pagina's)

Pagina afdrukken

INSTALLATION

CHANNEL STEP SETTING

Before using the unit for the first time, be sure to set the

correct channel step (FM and AM) for your area.

If the channel step setting is incorrect, tuning to the cor-

rect frequency will not be possible, and poor sound qual-

ity due to distortion and noise will prevent reproduction

of the received signal.

FM 100 kHz, AM 10 kHz:

Set to this position for areas with an FM reception step

of 100 kHz and AM 10 kHz.

FM 50 kHz, AM 9 kHz:

Set to this position, for areas with an FM reception step

of 50 kHz and AM 9 kHz.

NOTE:

When unsure about the channel allocation for your area,

consult your dealer for correct information.

To change channel steps

Setting the FM channel step to 100kHz and the AM

channel step to 10kHz:

When power is in standby, press the STANDBY/ON

switch while pressing STATION CALL button 0/10 to

switch power ON.

Setting the FM channel step to 50kHz and the AM

channel step to 9kHz:

When power is in standby, press the STANDBY/ON

switch while pressing STATION CALL button

switch power ON.

LOCATION

Install the tuner in a well-ventilated location

where it will not be exposed to high

temperatures or humidity.

Do not install the tuner in a location which is exposed to

direct rays of the sun, or near hot appliances or radiators.

Excessive heat can adversely affect the cabinet and in-

ternal components. Installation of the tuner in a damp or

dusty environment may result in a malfunction or acci-

dent. (Also avoid installation near cookers, etc., where

the tuner may be exposed to smoke, steam, or heat.)

CONDENSATION

When this unit is brought into a warm room from previ-

ously cold surroundings or when the room temperature

rises sharply,condensation may from inside,and the unit

may not be able to attain its full performance. In this case,

allow the unit to stand for about an hour or raise the room

temperature gradually.

POWER-CORD CAUTION

Handle the power cord by the plug. Do not pull out the

plug by tugging the cord and never touch the power cord

when your hands are wet as this could cause a short cir-

cuit or electric shock. Do not place the unit, a piece of

furniture, etc., on the power cord, or pinch the cord. Never

make a knot in the cord or tie it with other cords. The

power cords should be routed such that they are not likely

to be stepped on. A damaged power cord can cause fire

or give you an electrical shock. Check the power cord

once in a while. When you find it damaged, ask your near-

est PIONEER authorized service center or your dealer for

a replacement.

Maintenance of external surfaces

¶ Use a polishing cloth or dry cloth to wipe off dust

and dirt.

¶ When the surfaces are very dirty, wipe with a soft

cloth dipped in some neutral cleanser diluted five

or six times with water, and wrung out well, and

then wipe again with a dry cloth. Do not use furni-

ture wax or cleaners.

¶ Never use thinners, benzine, insecticide sprays or

other chemicals on or near this unit, since these

will corrode the surfaces.