Ariston aqualtis aq113d 697d Handleiding voor installatie en gebruik - Pagina 11

Blader online of download pdf Handleiding voor installatie en gebruik voor {categorie_naam} Ariston aqualtis aq113d 697d. Ariston aqualtis aq113d 697d 12 pagina's.

Pagina afdrukken

Trouble shooting

Your washing machine could occasionally fail to work. Before contacting the Technical Assistance Centre (see "Assistance"),

make sure that the problem cannot be solved easily using the following list.

Problem:

The washing machine does not

switch on.

The wash cycle does not start.

The washing machine does not fill

with water.

The washing machine door

remains locked.

The machine continuously fills

with water and drains.

The washing machine does not

drain or spin.

The machine vibrates a lot during

the spin cycle.

The washing machine leaks.

The icons corresponding to the

"Phase in progress" flash rapidly

at the same time as the ON/OFF

indicator light.

There is too much foam.

Note: to exit "Demo mode", switch machine off, press and hold the two

Possible causes / Solutions:

• The appliance is not plugged into the socket fully, or not enough to make

contact.

• There is no power in the house.

• The door is not closed properly.

• The START/PAUSE button has not been pressed.

• The water tap has not been opened.

• A delayed start has been set.

• The water inlet hose is not connected to the tap.

• The hose is bent.

• The water tap has not been opened.

• There is no water supply in the house.

• The pressure is too low.

• The START/PAUSE button has not been pressed.

• If you have selected the

machine drum will rotate slowly; to end the cycle press the START/PAUSE

button or the

button.

• The drain hose is not fitted at a height between 65 and 100 cm from the floor

(see "Installation").

• The free end of the hose is under water (see "Installation").

• If the dwelling is on one of the upper floors of a building, there may be

problems relating to water drainage, causing the washing machine to fill with

water and drain continuously. Special anti-draining valves are available in shops

and help to prevent this inconvenience.

• The wall drainage system is not fitted with a breather pipe.

• The wash cycle does not include draining: Some wash cycles require the drain

phase to be started manually (see "Wash cycles and options").

• The

option is enabled: to complete the wash cycle, press the START/

PAUSE button ("Wash cycles and options").

• The drain hose is bent (see Installation).

• The drainage duct is clogged.

• The drum was not unlocked correctly during installation (see "Installation").

• The machine is not level (see "Installation" ).

• The machine is trapped between cabinets and walls (see "Installation").

• The load is unbalanced (see "Detergents and laundry").

• The water inlet hose is not screwed on properly (see "Installation").

• The detergent dispenser is blocked (to clean it, see "Care and maintenance").

• The drain hose is not fixed in place properly (see "Installation").

• Switch off the machine and unplug it, wait for approximately 1 minute and

then switch it back on again. If the problem persists, contact the Technical

Assistance Service.

• The detergent is not suitable for machine washing (it should display the text

"for washing machines" or "hand and machine wash", or the like).

• Too much detergent was used.

function, at the end of the cycle the washing

and

buttons simultaneously for 3 seconds.