Pioneer A-107 Gebruiksaanwijzing - Pagina 2

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Pioneer A-107. Pioneer A-107 12 pagina's. Stereo
Ook voor Pioneer A-107: Servicehandleiding (8 pagina's), Gebruiksaanwijzing (13 pagina's)

Pagina afdrukken

Information to User

Alteration or modifications carried out without appropri-

ate authorization may invalidate the user's right to oper-

ate the equipment.

POWER-CORD CAUTION

Handle the power cord by the plug. Do not pull out the plug by

tugging the cord and never touch the power cord when your

hands are wet as this could cause a short circuit or electric

shock. Do not place the unit, a piece of furniture, etc., on the

power cord, or pinch the cord. Never make a knot in the cord

or tie it with other cords. The power cords should be routed

such that they are not likely to be stepped on. A damaged

power cord can cause fire or give you an electrical shock.

Check the power cord once in a while. When you find it

damaged, ask your nearest PIONEER authorized service

center or your dealer for a replacement.

MAINTENANCE OF EXTERNAL SURFACES

÷ Use a polishing cloth or dry cloth to wipe off dust and

dirt.

÷ When the surfaces are very dirty, wipe with a soft cloth

dipped in some neutral cleanser diluted five or six times

with water, and wrung out well, and then wipe again

with a dry cloth. Do not use furniture wax or cleaners.

÷ Never use thinners, benzine, insecticide sprays or other

chemicals on or near this unit, since these will corrode

the surfaces.

VOLTAGE SELECTOR SWITCH

Only multi-voltage model is provided with this switch.

U.K., European, Australian and New Zealand models are

not provided with this switch.

Main voltages in Saudi Arabia are 127 V and 220 V only.

Never use this model with 110 V setting in Saudi Arabia.

The line voltage selector switch is on the rear panel. Check

that it is set properly before plugging the power cord into the

AC outlet. If the voltage is not properly set or if you move to

an area where the voltage requirements differ, adjust the

selector switch as follows.

1. Disconnect the power cord.

2. Use medium-size screwdriver.

3. Insert the screwdriver into the groove on the voltage

selector and adjust so that the tip of the arrow points to the

voltage value of your area.

220V

110V

240V

120-127V