Pioneer A-40AE Gebruiksaanwijzing - Pagina 10

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Pioneer A-40AE. Pioneer A-40AE 24 pagina's.

Bi-wiring connections

a Speaker Cable

3/8"

(10 mm)

You can connect speakers that support bi-wiring to this unit.

Connect the treble and bass correctly.

0 When connecting, be sure to remove the jumper bar that

connects the tweeter jack and the woofer jack on the

speaker.

0 As shown on the illustration, the wiring terminals of

SPEAKERS B are connected to the tweeter and

SPEAKERS A are connected to the woofer. However,

wiring them the other way around is also possible.

0 Change the setting so that audio is output from both

SPEAKERS A/B. Refer to "Switching speaker output"

(p17) for details.

(Note) Speaker Impedance

Connect speakers with an impedance of 4 ≠ to 16 ≠.

0 Setup: You have to change the setting on this unit if any

of the connected speakers have 4 ≠ or more to less than

8 ≠ impedance. Change the speaker impedance setting

to 4 ≠. (p15)

Connect the Speaker Cables

Make correct connection between the unit's jacks and

speaker's jacks (+ side to + side, and - side to - side) for

each channel. If the connection is wrong, a bass sound will

not be reproduced properly due to reverse phase. Twist the

wires exposed from the tip of the speaker cable so that the

wires do not stick out of the speaker terminal when

Right

connecting. If the exposed wires touch the rear panel, or the

+ side and - side wires touch each other, the protection

circuit will be activated.

Preparations

Left