Pioneer GM-D1004 Gebruikershandleiding - Pagina 6
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Pioneer GM-D1004. Pioneer GM-D1004 45 pagina's. Class d four-channel amplifier
Ook voor Pioneer GM-D1004: Gebruikershandleiding (18 pagina's)
Pagina afdrukken
Section
03
Connecting the units
Connection of power cord
and speaker
CAUTION
Connect the yellow cord to the terminal linked to
the fuse unit of the car.
L
3
5
F
6
R
1 Fuse 15 A × 1
2 To power cord input
3 Left
4 Right
5 Front speaker
6 Rear speaker
7 White
8 White/black
9 Gray
a Gray/black
b Green
c Green/black
d Violet
6
En
1
2
R
4
7
9
8
a
d
c
e
f
g
h
e Violet/black
f Black (chassis ground)
Connect to a clean, paint-free metal location.
g Yellow
Connect to the constant 12 V supply terminal.
h Blue/white
Connect to system control terminal of the car
stereo.
Note
INPUT SELECT (input select) switch must be set.
For details, see Setting the unit on page 5.
Before connecting the
amplifier
WARNING
! Secure the wiring with cable clamps or adhe-
sive tape. To protect the wiring, wrap sections
in contact with metal parts in adhesive tape.
! Never cut the insulation of the power supply
to feed power to other equipment. Current ca-
pacity of the wire is limited.
CAUTION
! Never shorten any wires, the protection circuit
may malfunction.
! Never wire the speaker negative cable directly
to ground.
! Never band together multiple speaker's nega-
tive cables.
! If the system remote control wire of the ampli-
fier is connected to the power terminal via the
ignition switch (12 V DC), the amplifier will re-
main on with the ignition whether the car
stereo is on or off, which may exhaust battery
if the engine is at rest or idling.
! Install and route the Power cord, ground wire,
speaker wires and the amplifier as far away as
possible from the antenna, antenna cable and
tuner.