Pioneer GM-D7400M - Amplifier Gebruikershandleiding - Pagina 9
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Pioneer GM-D7400M - Amplifier. Pioneer GM-D7400M - Amplifier 38 pagina's. Class d mono amplifier
Ook voor Pioneer GM-D7400M - Amplifier: Gebruikershandleiding (6 pagina's), Servicehandleiding (31 pagina's), Gebruikershandleiding (16 pagina's)
Pagina afdrukken
Solderless Terminal Connections
• Do not connect a cord having an exposed core
wire to the power terminals of this amplifier
(Power terminal, GND terminal, System remote
control terminal). Disconnection or breakage of
the core wire can cause a fire or short-circuit.
• Since the wire will become loose over time, it
must be periodically inspected and tightened as
necessary.
• Do not solder or bind the ends of the twisted
wires.
• Fasten while making sure to not to clamp the
insulating sheath of the wire.
• Use the supplied hexagonal wrench to tighten and
loosen the terminal screw of the amplifier.
Securely fasten the wire with the terminal screw.
However, since excessively tightening the termi-
nal screw of the System remote control has the
risk of damaging the wire, be careful not to tight-
en excessively by observing the status of the wire
when tightening.
Connecting the Power Terminal
• We recommend that you use the special red bat-
tery and ground wire [RD-228], which is sold
separately. Connect the battery wire directly to
the car battery positive terminal (+) and the
ground wire to the car body.
• Recommended wires size (AWG: American Wire
Gauge) is as follows. The battery wire and the
ground wire must be same size.
• Use a 10 AWG to 20 AWG wire for the system
remote control wire.
Battery Wire and Ground Wire Size
Wire Length
less than
5.7 m
less than
18 ft.
Wire Size
8 AWG
less than
less than
9.0 m
14.4 m
less than
less than
29 ft.
47 ft.
6 AWG
4 AWG
1. Pass the battery wire from the
engine compartment to the interior
of the vehicle.
• After making all other connections to the
amplifier, connect the battery wire terminal
of the amplifier to the positive (+) terminal of
the battery.
Engine
Positive (+)
compartment
terminal
Fuse (40 A) × 2
Insert the O-ring rubber
grommet into the vehicle
body.
2. Connect the wires to the terminal.
• Fix the wires securely with the terminal
screws.
System remote
control terminal
Power terminal
Battery wire
WARNING
Failure to securely fasten the battery wire to the ter-
minal using the terminal screws could cause the ter-
minal area to overheat and could result in damage
and injury including minor burns.
Interior of
the vehicle
Drill a 13 mm
(1/2 in.) hole
into the vehi-
cle body.
Terminal screws
GND terminal
Ground wire
System remote
control wire
8