Ariston AVXXL149 Instructieboekje - Pagina 2

Blader online of download pdf Instructieboekje voor {categorie_naam} Ariston AVXXL149. Ariston AVXXL149 12 pagina's. Washing machine
Ook voor Ariston AVXXL149: Instructieboekje (12 pagina's)

Pagina afdrukken

Installation

! Keep this instruction manual in a safe place for future

reference. Should the appliance be sold, transferred or

moved, make sure the instruction manual accompanies

the washing machine to inform the new owner as to its

operation and features.

! Please read this instruction manual carefully: it contains

important information regarding installation, operation and

safety.

Unpacking

1. Unpack the machine.

2. Check whether the machine has been damaged during

transportation. If this is the case, do not install it and contact

your retailer.

Removing the transit fixings

IMPORTANT

IMPORTANT: Follow these instructions to remove the TWO

IMPORTANT

transit fixings ( see Description for location).

Situated on either side of the rear panel, BOTH transit

bolts MUST be removed before use.

! Failure to do so may cause

damage to your machine.

It is important the transit bolt and

spacer come out intact ( see pic

see pic ).

see pic

1. Unscrew the bolt using a 13mm

spanner.

2. STOP when 3 threads can be

seen.

3. Hold, slide sideways and pull to

remove.

4. For safety, insert one of the

plastic covers ( supplied with your

machine ) over the hole.

! Repeat steps 1 to 4 to remove the

second transit bolt.

! Packaging materials are not

children's toys.

Levelling

Your machine will be noisy if the two front feet are not

adjusted so that the machine stands firm and level.

! The machine should be levelled from side to side and

from front to back.

1. Move your machine into its final location.

- Take care not to trap or kink the hoses.

2. Turn one or both front feet anti-

clockwise by hand until the feet

cannot be turned any more.

When adjusting the feet, use a spirit

level to check the machine stands

level, from side to side and from

front to back.

- The spring on each foot will stop

them coming loose.

! If it is placed on a fitted or loose carpet, adjust the feet in

such a way as to allow enough room for ventilation beneath

the machine.

Water connection

Connecting the water inlet hose.

Remember that this is a cold-fill machine.

! Check that seal is in place inside

the hose end cap.

Before making the water connections to gas ¾ thread,

allow the water to run freely from the supply tap until it is

perfectly clear.

Screw the inlet end with the blue

cap onto the cold water supply tap.

Turn the tap on and check for leaks: tighten if necessary.

! Make sure that there are no kinks or bends in the hose.

! The water pressure at the tap must be within the values

indicated in the Technical details table (next page).

! If the water inlet hose is not long enough, contact a

specialist store or an authorised serviceman.

! Always use new hoses.

! Check the water hose at least once a year, replace any

that are cracked as worn hoses could split under water

pressure.