Ariston AW 125 Reparatiehandleiding - Pagina 8
Blader online of download pdf Reparatiehandleiding voor {categorie_naam} Ariston AW 125. Ariston AW 125 20 pagina's. Washer / washer-dryer combo
Ook voor Ariston AW 125: Gebruikershandleiding (23 pagina's)
Pagina afdrukken
- 1. Table of Contents
- 2. Model & Serial Number Locations
- 3. Top Panel
- 4. Control Panel
- 5. Control Panel Components
- 6. Toe Kick & Drain Motor
- 7. Drum Boot
- 8. Door Switch
- 9. Water Valves
- 10. Heater Assembly (AWD 120 / 121 / 129 Only)
- 11. Pressure Switch
- 12. Rear Access Panel
- 13. Control Board
- 14. Main Motor
- 15. Fault Codes
- 16. Schematics
4. CONTROL PANEL COMPONENTS - Program Selector
• To remove the Program Selector, first remove the Program Selector Knob by grasping it firmly and pulling it toward you (Fig. 4-6).
With the Knob removed loosen the Phillips Screw and remove the Program Knob Bezel (Fig. 4-7). Now rotate the Program Dial
until the half moon cut out lines up with the Program Selector Locking Tab (Fig 4-8).
• Using a small screwdriver push in on the Locking Tab (Fig. 4-9), while holding the Locking Tab in use your other hand to bring the
bottom of the Program Selector slightly away from the Mounting Plate, and then remove by sliding it up and off (Fig 4-10). In Fig.
4-11 you can see the four (4) alignment tabs that hold the Program Selector to the Program Selector Mounting Plate.
TECH NOTE: The Program Selector Mounting Plate does not have to be removed in order to remove the Program Selector.
TECH TIP: The Program Knob Bezel, Program Dial and Program Knob are all keyed to make re-installation easier.
REPAIR MANUAL
Fig. 4-6
2
Fig. 4-9
Fig. 4-7
1
Fig. 4-10
AW 120 / AW 122 / AW 125
AWD 120 / AWD 121 / AWD 129
Fig. 4-8
Fig. 4-11
Page: 5