Pioneer PDP-503MXE Technisch handboek - Pagina 21

Blader online of download pdf Technisch handboek voor {categorie_naam} Pioneer PDP-503MXE. Pioneer PDP-503MXE 25 pagina's. Plasma display monitor

Pagina afdrukken

3.2.2 Calculating heat quantity

As a curtesy to our customers, we have included the power formula to calculate the air conditioning needs.

For power consumption, allow for 400 W ≠ 400 VA per unit.

Since most of the power consumed is transformed into heat, power consumption may be regarded as roughly equal to

generated heat.

1 Conversion to calories

[W] × 0.86 = [kcal/h]

Heat generated per display: 400 W × 0.86 = 344 kcal/h

2 Conversion to British Thermal Units

[W] × 3.41 = [BTU/h]

Heat generated per unit: 400 W × 3.41 = 1364 BTU/h

3.2.3 Product mounting holes

We recommend using mounting hardware available from Pioneer. If you use other mounting hardware items, mount

them to the unit using the M8-bolt holes provided in the unit. Tighten the bolts with a torque between 50 and 80 kg/cm.

Applying a torque beyond these limits may lead to internal component failure.

• Locations of useable mount holes are shown below.

b holes

Always use a minimum of 4 mounting holes, evenly distributed on opposite sides of both the horizontal and

vertical center lines.

Use bolts that can be driven 12 to 18 mm into holes "a" or "b", as shown in the Side View above.

Do not block or cover air outlets and openings for ventilation on the rear panel.

Take precautions to prevent soiling walls behind the product with exhaust air discharged from the air outlets.

This unit incorporates glass components. Install only on flat surfaces.

Always turn every bolt by hand 2 or 3 times and check to make sure it is straight, then tighten it using a tool.

Do not over tighten bolts.

Do not use loctight or similar bonding products.

Please make sure that you use M8 (P=1.25) bolts. (other types of bolt cannot be used).

Vent (fan)

b holes

a holes

Center line

b holes

Rear view diagram

Installation Conditions

a Holes (6 places)

b Holes (14 places)

This unit

Center

line

holes

Side view diagram

Attaching

surface

Installation

bracket etc...

a hole

Bolt

12 to 18 mm

b hole

Bolt

12 to 18 mm