Ariston LST 11477 Gebruiksaanwijzing - Pagina 20

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Ariston LST 11477. Ariston LST 11477 28 pagina's.

Pagina afdrukken

Start-up and use

Starting the dishwasher

1. Turn the water tap on.

2. Open the door and press the ON/OFF button: you will hear

a short beep and the ON/OFF and wash cycle indicator lights

switch on for a few seconds.

3. Measure out the detergent (see below) .

4. Load the racks (see chapter entitled Loading the racks).

5. Select the wash cycle in accordance with the type of

crockery and its soil level (see Table of wash cycles) , by

pressing the P button; the indicator light corresponding to

the selected wash cycle will switch on.

7. Start the wash cycle by shutting the door: after a few

seconds have passed, a long beep signals the start of the

wash cycle.

8. Two short beeps and one long one indicate the end of the

wash cycle and the indicator light corresponding to the wash

cycle flashes slowly. Open the door, switch off the appliance

by pressing the ON/OFF button, shut off the water tap and

unplug the appliance from the electricity socket.

9. Wait for a few minutes before removing the crockery, in

order to avoid burns. Unload the racks, beginning with the

lower level.

- The machine will switch off automatically during

certain periods of inactivity, in order to minimise

electricity consumption.

Modifying a wash cycle in progress

If a mistake was made during the wash cycle selection

process it is possible to change the cycle, provided that it

has only just begun: open the door, taking care to avoid the

escaping steam, and press and hold the ON/OFF button; the

machine will switch off with a long beep. Switch the machine

back on using the ON/OFF button and select the new wash

cycle using the P button; start the cycle by closing the door.

Adding extra crockery

Without switching off the machine, open the door, taking

care to avoid the escaping steam, and place the crockery

inside the dishwasher. Close the door: the cycle starts from

the point at which it was interrupted.

Accidental interruptions

If the door is opened during the wash cycle, or if there is a

power cut, the cycle stops. It starts again from the point at

which it was interrupted once the door has been shut or the

electricity supply is restored.

Measuring out the detergent

A good wash result also depends on the correct

amount of detergent being used; exceeding the stated

amount does not result in a more effective wash and

increases environmental pollution.

Only use detergent which has been specifically

designed for dishwashers.

DO NOT USE washing up liquid.

Using excessive detergent may result in foam

residue remaining in the machine after the cycle has

ended.

The use of tablets is only recommended for models

which offer the MULTI-FUNCTIONAL TABLETS option.

To achieve the best results from each washing and

drying cycle, powder detergent, rinse aid liquid and

salt should be used.

Compartment A: Washing detergent

Compartment B: Pre-wash detergent

1. Open cover C by pressing

button D.

2. Pour in the detergent after

consulting the Table of wash

cycles:

• For powder detergent use

compartments A and B.

• For detergent in tablet form:

when the cycle requires 1 tablet,

place it in compartment A and

close the cover; when it requires 2, place the second tablet

at the bottom of the appliance.

3. Remove detergent residues from the edges of the

compartment and close the cover until it clicks.

Only available in selected models.