Aeotec AEOEZWA009 Handmatig - Pagina 2

Blader online of download pdf Handmatig voor {categorie_naam} Aeotec AEOEZWA009. Aeotec AEOEZWA009 7 pagina's.

SmartStart. Available in selected Z-Wave Plus devices built upon 500 series technology and all devices built

upon 700 series technology, SmartStart lets you setup Z-Wave devices in seconds.Using SmartStart enabled

apps, simply scan the QR code on any compatible app to connect it to your Z-Wave gateway.

Product Description

This device measures the three air quality parameters temperature, humidity and dew point and reports them to

a central controller. Besides this, the device can directly control groups of other Z-Wave devices on over- and

undershooting a set temperature and/or humidity parameter. This can be used to establish control loops for

temperature and humidity. The device wakes up every 15 minutes to measure the values and it will send

unsolicited reports when values change. Additionally, the device will report all values on request.

The AërQ Sensor is actively monitoring the danger of mould in a room based on the temperature and humidity

and will issue alarm warnings when critical air conditions met. Wireless Alarm and red and a green blinking

LED will indicate a mould condition. This local LED warning function is also available when the device is not

included in any Z-Wave network and works stand alone.

Please read the user manual before installing the product.

In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure

to reset the device into factory default. You can do this by performing an Exclusion operation as described

below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended to

use the primary controller of the previous network to make sure the very device is excluded properly from this

network.

Reset to factory default

This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only

be used when the primary controller is inoperable.

Keep the button pressed for 10 seconds. Then the green LED will start blinking. Release the button, when the

LED stops blinking. Your device is reset to factory default now.

Safety Warning for Batteries

The product contains batteries. Please remove the batteries when the device is not used. Do not mix batteries

of different charging level or different brands.

Just place the device on any flat surface. Please keep in mind that the temperature may be different in different

locations inside the room. If placed too close to the heating both temperature, humidity and dew point values

may be wrong. The device is IP 20 rated. This means that is must not be exposed to direct water (rain). It is

safe to use the device in a humid environment such as a bathroom or dedicated washing facility.

Inclusion/Exclusion

On factory default the device does not belong to any Z-Wave network. The device needs to be added to an

existing wireless network to communicate with the devices of this network. This process is called Inclusion.

Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated

by the primary controller of the Z-Wave network. This controller is turned into exclusion respective inclusion

mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.

Inclusion

1. Insert the battery.

2. Press the button quickly three times in a row.

Exclusion

1. Press the button quickly three times in a row.