Aeotec ZW187 Gebruikershandleiding - Pagina 9

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Aeotec ZW187. Aeotec ZW187 9 pagina's. Recessed door sensor gen7
Ook voor Aeotec ZW187: Handmatig (11 pagina's)

Pagina afdrukken

Testing Health Connectivity.

NOTE - This health detection function is only good for determining the direct connection to the gateway (within

communication distance to your gateway without any other repeater nodes).

You can determine the health of your Recessed Door Sensor 7 connectivity to your gateway using its manual

button press, hold, and release function which is indicated by the LED.

Your gateway/controller/hub must support displaying Z-Wave device health in order for you to see the health of

your Recessed Door Sensor 7 to your Z-Wave gateway.

Follow these steps to test the health of your Recessed Door Sensor 7 to your Z-Wave gateway/controller/hub:

Press and hold the Z-Wave Button for 5-10 seconds to test the communication health your Recessed Door

Sensor 7.

@1 second, LED will turn off.

@2 seconds, LED will breath its LED

@5 seconds, LED will flash its LED

Release the Action Button to test the health.

If the LED sped up it's flashing, you have held it for too long.

Once the test is finished, the Recessed Door Sensor 7 will forward a Power Level Report command to your Z-

Wave gateway to display the communication quality. Some gateways do not support Power Level Command

Class in its interface and may not show.

More Advanced Conﬁgurations.

Recessed Door Sensor Gen7 has a longer list of device conﬁgurations that you can do with Recessed Door Sensor

Gen7. These are not exposed well in most gateways, but at the least, you can manually set conﬁgurations through

most Z-Wave gateways available. These conﬁguration options may not be available in a few gateways.

You can ﬁnd the conﬁguration sheet here: https://aeotec.freshdesk.com/helpdesk/attachments/6092013991

(https://aeotec.freshdesk.com/helpdesk/attachments/6092013991)

If you have any questions on how to set these, please contact support and let them know what gateway you are

using.