Dingtek DF702 Gebruiksaanwijzing - Pagina 10

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Dingtek DF702. Dingtek DF702 14 pagina's.

Indicates that the location of the device and the object is not correct;

√：

Step 3 Use the magnet to restart the device

To restart the device: The position of the opposite side of the white marked pin

is the magnetic switch position. The magnet can be restarted by placing the

magnet in the magnetic switch position for 3 s and then removing the magnet.As

shown in Figure 5.6.(Each time the device is restarted, the device will report the

data once.)

Note:

1 When the device is restarted, there is no free LED or sound outside the

casing to indicate that the restart is successful.

2 But when the restart is successful, you can see that a led on the main circuit

board will be on, and when the data is sent, the led will go out.

Step 4 Observe the data of the previous step 3 on the application platform

provided by our company. At this time, the trash should display full. (Note: We

will provide you with a platform test account after shipment.)

Step 5 Move the object and increase the distance d to make d>30. After 10

minutes (this time is the time from the previous data), the data can be observed

again. At this time, the trash can display is not full.

Repeat steps 4 and 5 to test empty/full status and different height values;

Note:

Beijing Dingtek Technology Corp., Ltd.

http://www.dingtek.com

Room A209, Flounder Business Park, Shunbai Road 12, Chaoyang District, Beijing, China 100022

Figure 5.6

Tel:86-10-64718863,64753700

Page