Aeotec AEOEZW111 Handmatig - Pagina 4

Blader online of download pdf Handmatig voor {categorie_naam} Aeotec AEOEZW111. Aeotec AEOEZW111 10 pagina's.

Pagina afdrukken
enhanced features.
IMPORTANT: Controllers may only allow configuring signed values. In order to set values in the range 128 ... 255 the value sent in the application shall be the desired
value minus 256. For example: To set a parameter to 200 it may be needed to set a value of 200 minus 256 = minus 56. In case of a two byte value the same logic
applies: Values greater than 32768 may needed to be given as negative values too.
Parameter 3: Current Overload Protection.
Output Load will be turned off automatically after 30 seconds and if the current overrun 1.5A.
Size: 1 Byte, Default Value: 1
Setting
0
1
Parameter 4: Overheat protection.
Output Load will be turned off automatically after 30 seconds and if the temperature of product inside exceeds 100°C.
Size: 1 Byte, Default Value: 0
Setting
0
1
Parameter 20: Configure the output status after re-power on it.
Configure the output status after re-power on it.
Size: 1 Byte, Default Value: 0
Setting
0
1
2
Parameter 80: To set which notification would be sent to the associated devices (Group 1)
To set which notification would be sent to the associated devices (Group 1) when the state of Nano Dimmers load is changed.
Size: 1 Byte, Default Value: 0
Setting
0
1
2
3
4
Parameter 81: To set which notification would be sent to the associated nodes in association group 3
To set which notification would be sent to the associated nodes in association Group 3 when using the external switch 1 to switch the loads.
Size: 1 Byte, Default Value: 1
Setting
0
1
Parameter 82: To set which notification would be sent to the associated nodes in association group 4
To set which notification would be sent to the associated nodes in association Group 4 when using the external switch 2 to switch the loads.
Size: 1 Byte, Default Value: 1
Setting
0
1
Parameter 85: Set appointment 1
Set the ON time of output load.
Size: 4 Byte, Default Value: 1573017
http://manual.zwave.eu/backend/make.php?lang=en&sku=AEOEZW111
Description
Disable
Enable
Description
Disable
Enable
Description
Last status
Always on
Always off
Description
Send Nothing
Send Hail CC
Send Basic CC report
Send Multilevel Switch report
Send Hail CC when using the manual switch to change the load state.
Description
Send Nothing
Send Basic Set CC
Description
Send Nothing
Send Basic Set CC
30-09-2020 12:35
Pagina 4 van 10