Ariston microSYSTEM Handleiding voor installatie-instructies - Pagina 6

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Ariston microSYSTEM. Ariston microSYSTEM 24 pagina's. Type c boilers

Pagina afdrukken

WARNING!!

The addition of anything that may interfere with the normal operation of the

appliance without express written permission of the manufacturer or his

agent could invalidate the warranty. In GB this could also infringe the GAS

SAFETY(Installation and Use) REGULATIONS.

In the Republic of Ireland the installation and initial start up of the appliance

must be carried out by a Competent Person in accordance with the current

edition of I.S.813 "Domestic Gas Installations", the current Building

Regulations, reference should also be made to the current ETCI rules for

electrical installation.

The appliance may be installed in any room or indoor area, although

2.3

ITING THE

PPLIANCE

particular attention is drawn to the requirements of the current I.E.E. Wiring

Regulations, in Scotland, the electrical provisions of the Building

Regulations applicable in Scotland, and in the Republic of Ireland, the

current edition of I.S.813, with respect to the installation of the combined

appliance in a room containing a bath or shower. The location of the boiler in

a room containing a bath or shower should only be considered if there is no

alternative.

Where a room-sealed appliance is installed in a room containing a bath

or shower reference should be made to the relevant requirements.

In GB this is the current I.E.E. WIRING REGULATIONS and BUILDING

REGULATIONS. In IE reference should be made to the current edition

of I.S.813 and the current ETCI rules.

If the boiler is to be sited into a timber framed building, reference must be

made to the current edition of the Institution of Gas Engineers Publication

IGE/UP/7 (Gas Installations in Timber Framed Housing).

The location must permit adequate space for servicing and air circulation

around the appliance as indicated in Section 2.5.

The location must permit the provision of an adequate flue and termination.

For unusual locations special procedures may be necessary.

BS 6798-1987 gives detailed guidance on this aspect.

A compartment used to enclose the appliance must be designed specifically

for this purpose. No specific ventilation requirements are needed for the

installation within a cupboard.

This appliance is not suitable for outdoor installation.

The type C appliances (in which the combustion circuit, air vent intake

and combustion chamber are air-tight with respect to the room in

which the appliance is installed) can be installed in any type of room.

Secondary ventilation is not required with this boiler. The boiler must be

installed on a solid, non-combustible, permanent wall to prevent access from

the rear.