Whirlpool 3347017 Installatie-instructies - Pagina 3
Blader online of download pdf Installatie-instructies voor {categorie_naam} Whirlpool 3347017. Whirlpool 3347017 5 pagina's. Top-load washer
Pagina afdrukken
--
-
auuw awn...
With Washer in Laundry Area.
1
Remove tape that covers
H shipping strap. Pull to completely
remove the shipping strap from the
inside of the washer. Read, then
remove label that covers power cord
and drain connector.
Peel the tape
down and off each side of cabinet.
Pull firmly to remove the other end of
the shipping strap from the back of the
washer. The shipping strap plug must
be completely
removed from the
washer for the self-leveling
legs to be
released.
Use new hoses and washers that
came with your Whirlpool washer.
washer
inseti-a flele
intoeuchend
-
of the inlet hoses. Check that washers
are firmly seated in couplings.
Inlets are plastic.
,
*
4
Attach hose to bottom inlet
avalve
opening
first; then
second hose to top inlet. Tighten
couplings
by hand. Then use pliers to
make an additional
two-thirds turn.
5.
If your washer
has a literature fl
rack, insert the
,/,/-JQ
tabs on sides
'
,,-
-=
-ir
in back bane1 of washer, f&.J
and bottom of
"
literature rack into holes
Gently push in and down /
7
?
I
until all tabs lock.
Place hose clamp
over washer drain
connector.
Push
coupling
end of
drain hose onto
washer connector.
Use pliers to open
clamp and slide clamp over drain
hose. Check for good fit.
Numbers
correspond
to steps.
7
Slide nozzle end
a
of drain hose
through the
small "loop"
in the wire form. Wrap the
hook end of the wire form
around the drain hose to
form
a
"hook shape:'
8
Move washer close to final
n
position. Put "hook" end
of drain hose into laundry tub or
standpipe.
Check for proper length
.
ot drain hose.
If drain hose is too long -
n
disconnect.
Remove clamp
and coupling.
Estimate length of drain
hose needed.
Cut flexible end of hose.
(Do not cut hook-shaped
end of drain
hose.)
Push and twist coupling
securely
onto drain hose. [You should feel top
of hose through coupling.]
Slide clamp
over coupling
and hose. Reinstall
drain hose. See step 6.
DO NOT FORCE EXCESS LENGTH
OF DRAIN HOSE DOWN THE
STANDPIPE. THIS COULD CAUSE
SIPHONING.
', -j: \ 5,'~ /
! --
1'
1 ii
10
Before
attaching
n
water inlet hoses,
run water through both faucets to get
rid of particles in water lines.
11.
Attach bottom hose (inlet marked "H")
to hot water faucet. 'Attach top hose
[inlet marked "C") to cold water faucet.
Tighten coupling
to faucet by hand,
then use pliers to make final two-thirds
turn.
PANEL B