Whirlpool 3LWTW4840YW Producthandleiding - Pagina 5

Blader online of download pdf Producthandleiding voor {categorie_naam} Whirlpool 3LWTW4840YW. Whirlpool 3LWTW4840YW 24 pagina's.

Pagina afdrukken
3.
Remove packing tray from tub
Remove tape from washer lid, open lid and remove cardboard
packing tray from tub. Be sure to remove all parts from tray.
NOTE: Keep tray in case you need to move washer later.
4.
Free power cord
Firmly grasp power cord plug and pull to free from rear panel.
Gently place power cord over console to allow free access
to back of washer.

CONNECT DRAIN HOSE

5.
Attach drain hose to drain port
Remove the red plastic plug from the black drain port on the
back of the washer.
If clamp is not already in place on elbow end of drain hose, slide
it over end as shown. Squeeze clamp with pliers and slide black
elbow end of drain hose onto black drain port and secure with
clamp.
For a laundry tub or standpipe drain, go to step 6.
For a floor drain, remove the preinstalled drain hose form as
shown in Step 7. You may need additional parts with separate
directions. See "Tools and Parts".
6
6.
Place drain hose in standpipe
Drain
hose form
114 mm
(4.5")
Place hose into standpipe (shown in picture) or over side of
laundry tub.
IMPORTANT: 114 mm (4.5") of drain hose should be inside
standpipe; do not force excess hose into standpipe or lay
on bottom of laundry tub. Drain hose form must be used.
7.
Remove drain hose form (floor drain
installations only)
For floor drain installations, you will need to remove the drain
hose form from the end of the drain hose. You may need
additional parts with separate directions. See "Tools and Parts".