Whirlpool 3LWTW5550 Handleiding voor installatie-instructies - Pagina 3

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Whirlpool 3LWTW5550. Whirlpool 3LWTW5550 44 pagina's.

Pagina afdrukken

Parts supplied:

NOTE: All parts supplied for installation are in the

cardboard insert in the top of the washer.

Drain hose with clamp,

form, and cable tie

Inlet hoses

Plugs and cord lock cover

Alternate parts:

(Not supplied with washer)

Your installation may require additional parts. To order, please

contact the dealer from whom you purchased your washer or

an authorized service company.

If you have:

Overhead sewer

25 mm (1") standpipe

Drain hose too short

Lint clogged drain

"Y" connector

Rubber washer

You will need:

Standard 76 L (20 gal.) 990 mm (39")

tall drain tub or utility sink, sump

pump and connectors (available

from local plumbing suppliers)

51 mm (2") diameter to 25 mm (1")

diameter Standpipe Adapter

Part Number 3363920

Connector Kit Part Number 285835

Extension Drain Hose Part

Number 285863

Connector Kit Part Number 285835

Drain Protector Part Number 367031

Connector Kit Part Number 285835

SPECIFICATIONS

Technical Specifications:

220–240 V ~50 Hz. AC, 1ph 650 Watts, IP24

Dry Linen Capacity

10,5 kg (23 lb)

These units are sold in multiple regions with different

requirements for measuring capacity. Below are a few

of the valid forms of measure posted on this product:

Dry Linen Capacity: A weight measure that reflects a maximum

load size that can be loaded into the washer.

IEC Capacity: The capacity measure that represents the

maximum capacity of dry linens and textiles which the

manufacturer declares can be treated in a specific cycle.

LOCATION REQUIREMENTS

Select proper location for your washer to improve performance

and minimize noise and possible "washer walk". Install your

washer in a basement, laundry room, closet, or recessed area.

699 mm

(27

1067 mm

(42")

You will need:

A water heater set to 49° C (120° F).

An earthed electrical outlet located within 1,2 m (4 ft) of power

cord on back of washer.

Hot and cold water faucets located within 0,9 m (3 ft) of hot

and cold water fill valves on washer, and water pressure

of 20-100 psi (138-690 kPa).

A level floor with maximum slope of 25 mm (1") under entire

washer. Installing on carpet is not recommended.

Floor must support washer's total weight (with water and load)

of 143 kgs (315 lbs).

IMPORTANT: Do not install, store, or operate washer where it will

be exposed to weather or in temperatures below 0° C (32° F).

Water remaining in washer after use may cause damage in low

temperatures. See "Washer Care" in your Use and Care Guide

for winterizing information.

Proper installation is your responsibility.

IEC Capacity

7,5 kg (16,5 lb)

686 mm

(27")