Whirlpool 3MAS4132FW1 Gebruiks- en onderhoudshandleiding - Pagina 11

Blader online of download pdf Gebruiks- en onderhoudshandleiding voor {categorie_naam} Whirlpool 3MAS4132FW1. Whirlpool 3MAS4132FW1 16 pagina's.

Whirlpool 3MAS4132FW1 Gebruiks- en onderhoudshandleiding
C
ARING FOR
C
LEANING YOUR WASHER
Cleaning the exterior
Use a soft, damp cloth or sponge to wipe up any
spills such as detergent or bleach. Oc-
casionally wipe the outside of
your washer to keep it looking new.
W
INTER STORAGE
Install and store your washer where it will not
freeze. Because some water may stay in the
hoses, freezing can damage your washer. If storing
or moving your washer during freezing weather,
winterize it.
To winterize washer:
1.
Shut off both water taps.
2.
Disconnect and drain water inlet hoses.
3.
Put 1 L (1 quart) of R.V.-type antifreeze in the
basket.
4.
Run washer on a drain and spin setting (see
"Rinse/Drain and Spin") for about 30 seconds
to mix the antifreeze and water.
5.
Unplug the power supply cord.
I
NLET HOSES
Replace inlet hoses after 5 years of use to reduce
the risk of hose failure. Inspect and replace inlet
hoses if bulges, kinks, cuts, wear, or leaks
are found.
Y
W
OUR
ASHER
,
,
MOVING
VACATION CARE
Cleaning the interior
Clean your washer interior by mixing 250 mL (1 cup)
of chlorine bleach and 500 mL (2 cups) of detergent.
Pour this into your washer and run it through a com-
plete cycle using hot water. Repeat this process if
necessary.
NOTE: Remove any hard water deposits using only
cleaners labeled as washer safe.
To use washer again:
1.
Flush water pipes and hoses.
2.
Reconnect water inlet hoses.
3.
Turn on both water taps.
4.
Reconnect power supply cord.
5.
Run the washer through a complete cycle with
250 mL (1 cup) of detergent to clean out
antifreeze.
Non-use or vacation care:
Operate your washer only when you are at home. If
you will be on vacation or not using your washer for
an extended period of time, you should:
Unplug the power supply cord or turn off electrical
power to the washer.
Turn off the water supply to the washer. This helps
avoid accidental flooding (due to a water pressure
surge) while you are away.
When replacing your inlet hoses, mark the date of
replacement on the label with a permanent marker.
11